片语

friction axis loss factor摩擦损耗系数

friction head loss摩擦水头损失

friction axis loss摩擦损耗

friction pressure loss摩阻压力损失

friction press loss摩擦压力损失

friction n loss摩擦损失

friction energy loss摩擦能量损耗

friction n loss coefficient摩擦损失系数

friction power loss摩擦功率损耗

英汉例句

• recounted friction loss circumstance on parts of the second-row shroud-ring in the curtis stage for n12 turbine's rotor.

  根据启动试验结果和大修检查发现的问题，介绍了转子复速级第二列复环局部严重磨损的情形。

• motor shall be regularly maintenance (lubricating), and reduce the friction loss of motor.

  电动机应定期保养（润滑加油），可减少电动机的摩擦损失。

• it has high efficiency because of low turning speed that reducing the friction loss and the pm body excitation can remove the slip-ring loss.

  由于低速运转减少了摩擦损耗、永磁体励磁消除了滑环损耗、因此具有较高的效率；

• although there are many kinds of disk friction loss formulas, practical computation indicates that the results of these formulas are not exact and the windages can not be neglected.

  虽然计算离心泵圆盘摩擦损失的公式较多，但实际计算表明这些公式的计算结果都存在较大偏差。

• influence of the geometric parameters of the molded lines of scroll compressors on their friction loss power;

  通过实例说明了这些规律在变频涡旋压缩机设计中的作用。

• the friction loss of saw chain is different from general friction loss, it contains relative motion surface friction loss and shock loss two factors.

  锯链的摩擦损失不同于一般的摩擦损失，它包括相对运动表面的摩擦损失和沖击损失两个因素。

• this paper determines standard uncertainty for measurement of windage and friction loss of three-phase induction motor through fitting line of least square method.

  本文用最小二乘法拟合的直线确定三相异步电动机风摩耗测量的标準不确定度。

• friction loss takes the most amount of the mechanical loss in internal combustion engines.

  在发动机功率损失中，摩擦损失占相当大的比例。

• on the base of experiments, factors of effect on the gasoline engine friction loss are analysed.

  在试验基础上，分析了影响汽油机整机摩擦损失的因素。

• the results show that the friction loss increases with the increase of the particle diameter, density, volumetrical concentration of the solid phase and the velocity of liquid phase.

  计算结果表明，摩擦损失随固相颗粒直径、密度、浓度和液相速度的增大而增加。

• the pump performance would be affected by the two clearances in such a way that the clearance alters both volumetric leakage power loss and mechanical power loss (dick friction loss of impeller).

  口环间隙通过改变离心油泵的容积损失功率和机械损失功率（叶轮圆盘摩擦损失）影响离心油泵性能。

• as the existence of the horizontal curvature, the result of friction loss is different from 「standardize」.

  由于水平曲率的存在，空间曲线预应力束的摩阻损失与规范计算的结果存在差异。

• the optimum passage section figure of rectangle is square, and the rectangle has 4 optimum comer circular arcs which make the hydraulic loss of friction loss of per unit length passage the least.

  矩形流道断面以正方形为最优，且存在最优角圆，使单位长流道沿程水力损失最小。

• however, because of the existence of tabs, the flow friction loss in the film hole will be increased.

  但突片的存在也增大了气流在气膜孔中的流动阻力。

• researched friction loss and ultimate strength of external prestressing tendon considering deviator curvature radius and bending angle of prestressing tendon.

  研究了转向块曲率半径、钢绞线弯折角度等对预应力摩擦损失和体外预应力筋极限强度的影响；

• the optimal area ratio is singly related with friction loss coefficient, and it is not related to the density ratio of fluids.

  最优面积比只与摩擦损失系数有关，而与流体间的密度比无关。

• by the friction loss experiment, the reasonable friction and deviation coefficient can be acquired; the regular pattern of prestressed friction loss can be discovered.

  通过预应力束摩阻损失测试得到了合理的预应力孔道摩阻系数和偏差系数以及预应力摩阻损失规律。

• the friction loss coefficients of throat and spreading pipes are major factors influencing the efficiency.

  喉管与扩散管的摩擦损失系数是影响效率的主要因素。

• the equation for friction loss along the plastic pipe of micro irrigation is presented adopting the multiple regression analysis according to existing friction loss equation.

  根据已有的塑料管沿程水头损失计算公式 ，采用多元线性回归计算方法 ，提出了微灌塑料管沿程水头损失计算公式。

• different vehicles in the energy dissipation power transmission process will have different for car, for all kinds of vehicle parts processing quality of different friction loss caused by different.

  不同的车辆在动力传递过程中的能量损耗会有不同，同为新车，也会因为各种车辆零部件加工质量的不同而造成摩擦损耗的不同。

• it is shown that the friction loss is about 60 percent of the total loss.

  研究结果表明：磨擦损失功率约占整机机械损失功率的60％。

• the transient prestress loss includes the friction loss and anchorage loss.

  瞬时预应力损失包括摩擦损失和锚固损失。