片语

large ground deformation大变形

large mesh deformation网格大变形

large dam deformation monitoring大坝位移监测

large plastic deformation大塑性变形

large range deformation大范围变形量

large elastic deformation大弹性形变

large scale deformation analysis大变形分析

large film deformation薄膜大变形

英汉例句

• the application of an absolute nodal coordinate (anc) formulation in the coupling dynamics of flexible beams with large deformation was investigated.

  研究了绝对坐标法在大变形柔性梁系统刚-柔耦合动力学问题中的应用。

• dynamic response analysis of tensioned cable and membrane structure is one of difficulties of structure design because of its tensioned-only, large deformation and small strain property.

  由于膜材只能受拉不能受压以及大变形小应变的特点，其设计中动力响应分析是难点之一。

• the bolting design of large deformation surrounding rock usually depends on experience, one of the main reasons is the bearing capacity of bolts.

  大变形围巖的锚桿支护设计一般还是采用经验类比法，主要原因之一是不能合理确定锚桿的承载能力。

• this paper gives the exact relations between strains and displacements for large deformation of elastic thin shells.

  本文给出了弹性薄壳大变形时应变与位移之间的精确关系。

• a 16 node shell element with relative degrees of freedom was developed for large deformation analysis of plate and shell structures.

  为了简便有效地解决板壳结构的大变形问题，针对16节点相对自由度壳单元进行研究。

• the problem is considered as dynamic response of the structure subjected to specified initial velocity or impulse load, with large deformation and plasticity.

  问题被当作结构在规定初速度或脉沖载荷作用下的非线性（大变形与弹塑性）动反应。

• finally, a numerical instance of rubber beam bending deformation is given to demonstrate that the method is highly accurate and self-adaptive in solving large deformation engineering problems.

  通过给出橡胶梁弯曲变形的数值算例，说明再生核粒子方法在解决大变形等工程问题上有着精度高，自适应能力强等特点。

• based on the basic principle of large deformation body put forward by chen zhida, it is unreasonable to study large deformation tunnel with small deformation theory.

  基于陈至达提出的大变形问题基础理论，指出了以传统小变形理论研究软弱围巖隧道大变形问题存在的弊端。

• the results indicate that the extension of ssrdem is correct, and three dimensional ssrdem is efficacious in modeling the discontinuous large deformation of rock mass.

  结果表明，推导出的算法是正确的，三维静态同步松弛离散单元法可用于模拟巖体的非连续大变形。

• this large deformation is called for rock dilatancy if volume dilation only occurs owing to stress redistribution.

  这种大变形如果仅是应力重分布引起的体积膨胀则称为巖石扩容。

• this paper proposed the concept of the large deformation and stability of tunnelling.

  提出了隧道大变形以及大变形隧道稳定性的概念。

• the article draws the conclusion that the method can be used to define complex construction large deformation and can be used to study engineering problem.

  结论通过建立桿件大变形问题计算新方法，为复杂结构系统大变形问题计算，提供一种可行的分析方法。

• in the paper, large deformation of symmetry fission has been described by a biquadratic surface revolution instead of several quadratic equations.

  本文用四次方程代替常用的几个二次方程曲线的回转体，来描述对称裂交的大形变过程。

• in this paper, after large deformation, scanning fractograph of tungsten alloys have been studied, and the influence of large deformation level on microstructure and properties has been analysed.

  研究了高强度钨合金材料大变形量锻造后的扫描断口，并结合力学性能变化规律分析了大变形对材料组织和性能的影响。

• however to the large deformation shaft without crack, general predictive theory has been applied to built up the multi-steps straightening stroke predictive algorithm.

  针对单弧度弯曲大变形无裂纹轴校直问题，根据广义预测控制理论，建立了多步校直行程预测算法。

• this paper introduces the lectotype of the lattice shell structure in the stadium of jiangning nanjing and analyzes the influence of joint rigidity and large deformation on the structure.

  本文针对南京江宁体育场看台斜拉网壳结构，介绍了结构设计的选型，分析节点刚度及大变形对结构的影响。

• the nonlinear strain components of shells are the foundations of the nonlinear shell mechanics. they are used in the stability and various large deformation analyses of shells.

  壳体的非线性应变分量是非线性壳体力学的基础，在壳体的稳定以及各种大变形问题中须要用到它们。

• an optimum algorithm is proposed to solve the geometrically nonlinear problem of large deformation of a cantilever under pressure on free end.

  提出一种解决几何非线性问题的优化算法，研究了悬臂压桿的几何非线性大变形问题。

• further research can be performed on large deformation of this joint based on structure optimization, improvement on manufacturing technology, posture sensor system and control algorithms.

  进一步的研究可以在优化结构、完善加工工艺、检测系统、改善控制算法的基础上对关节的大变形进行研究。

• the differences between conventional tmcp and new type tmcp were compared, and two mechanisms of low temperature large deformation for fine-grained were summarized.

  比较了传统tmcp与新型tmcp的异同，总结了目前采用的细化晶粒低温大变形方法的两种机制。

• the effects of geometric large deformation and impact action were taken into account in dynamic analysis.

  分析中采用了动力方法，考虑了几何大变形和沖击作用的影响。

• a general practical finite element analysis model for two-dimentional elastic large deformation contact problems was established using the tl method.

  用tl法分析研究，建立了二维弹性大变形接触问题的一般实用有限元分析模型。

• because of the application of explicit difference method, it is especially suitable to elastoplastic analysis, large deformation analysis and construction process simulation.

  由于采用显式差分法，它尤其适合于材料的弹塑性、大变形分析以及施工过程的模拟。

• method the finite element method was employed to perform the stress analysis on this valve, which included the material nonlinearity, large deformation and the contact condition.

  方法考虑材料非线性，大变形和接触条件建立有限元模型，采用有限元法进行应力分析。

• in order to assure the stability of the large deformation elastoplastic analysis, the lagrangre material shape function deformed with material was used to analyze the splitting rolling process.

  为保证大变形弹塑性分析的稳定性，采用随材料变形的拉格朗日物质形函数分析了整个切分轧制过程。

• the method of plate and shall large deformation rotation analysis is used in wangying coal mining district, fuxin area to predict faults and fractures in coal seams.

  用板壳大变形理论转动角计算方法，对阜新矿区王营井田煤层大变形断裂和破裂带进行分析和预测。

• basing on the elastic bending theory of beams in large deflection, the non-linear shearing behavior of cellular materials under large deformation is studied in the paper.

  将梁的弹性大挠度弯曲理论应用于蜂窝壁板，研究了大变形条件下蜂窝材料的非线性剪切变形行为。