英语释义

• supplementary nut that is screwed down on a primary nut to prevent it from loosening

片语

conduit locknut制管圈

hex locknut六角锁定螺母

self-locking nut[机] 自锁螺母

pulley locknut带轮防松螺帽

blocking nut防松螺母，锁紧螺帽

locknut adjustment锁紧螺母调整

Switch locknut开关锁紧螺母

locknut installation锁紧螺母安装

differential locknut差速器防松螺母

screw locknut螺钉锁紧螺母

Standard Locknut螺母轴承

英汉例句

• a sealed collet having improved radial flexibility is provided for facilitating removal from a locknut of a chuck assembly.

  本发明提供了一种具有改进的径向挠性的密封套爪以有利于从卡盘组件的防松螺母上卸除。

• and 6 intake valves. tighten valve adjusting screw locknut to 27 n·m (20 lb-ft).

  将气门调节螺丝防松螺母拧紧至27牛顿·米（20磅-呎）。

• the locknut is rotated to lock the spring chuck, so as to clamp a drill bit which is enabled to rotate along with the spindle to carry out the drilling processing.

  通过转动锁紧螺母锁紧弹簧夹头从而夹紧鉆头，使鉆 头跟随主轴旋转进行鉆削加工。

• to replace seat/ stem module shut off supply, loosen locknut and back off adjusting screw.

  要更换阀座/桿模块，先关闭供应管道，松开锁紧螺母，退出调节螺丝。

• the valve is mainly made up of handle, body, disc, locknut and seal etc.

  手动密闭闸阀主要由把手、阀体、插板、锁紧螺钉、密封装置等部件组成。

• if valve clearance needs to be adjusted, loosen the locknut on rocker arm adjusting screw. turn adjusting screw until feeler gauge slips with a slight drag.

  如果气门间隙需要调节，松开摇臂调节螺丝上的防松螺母，转动调节螺丝直到测隙规滑动时稍带阻力为止。

• the locknut torque needed to move the washer at the maximum washer interference fit shall not exceed the torques given in table 3.

  锁紧螺母扭矩压紧垫片时，其与垫片的最大相互作用力不能超过表3所给扭矩值。

• now, add a locknut groove on the right edge of the section to the selected shaft section.

  现在，将剖面右侧边上的防松螺帽槽加入至选取的轴剖面中。

• position locknut over top of fuel pump module.

  将锁定螺帽放在燃油泵模组上。

• recheck clearance on all valves again after locknut is tightened.

  防松螺母拧紧后，再对所有气门的间隙重新检查一次。