片语

DC Offset Direct Current直流补偿

Input Offset Current[电] 输入补偿电流；输入失调电流；输入偏移电流

equivalent input offset current等效输入补偿电流

4mA offset currentmA偏置电流

ma offset currentma偏置电流

drift input offset current输入偏移电流漂移

offset current and voltage失调电流和电压

offset fault current故障偏移电流

Input Offset Current Drift输入失调电流漂移

英汉例句

• it might make sense to realize some of those losses to offset current or future gains as part of your periodic portfolio rebalancing.

  实现一些损失抵销目前或以后的盈利作为你一段时期内投资组合的再平衡也许可行。

• any offset current flowing through a high impedance device will cause an unwanted voltage to appear across the device.

  通过高阻装置的任何偏移电流都会导致装置两端出现不希望的电压。

• thus, the ac motor control device can suppress generation of an offset current when performing the rectangular wave voltage control.

  由此，在进行矩形波电压控制时能够抑制失调电流的产生。

• as with the contact potential, the uncertainty added to a small current signal by the offset current can be calculated.

  和接触电势一样，由于偏移电流而引起的小电流信号测量不确定度亦可计算获得。

• however, determining the offset current of the entire system may be difficult.

  然而，确定整个系统的偏置电流可能很困难。

• an electrometer makes an ideal coulombmeter because it has very low input offset current and high input resistance.

  静电计是一个理想的库侖计，因为它具有非常低的输入偏置电流和很高的输入电阻。

• as shown in figure 2-18, the external offset current also adds to the source current, and the meter again measures the sum of the two.

  如图2-18所示，外部偏置电流也加到源电流上，仪表显示的也是这二者之和。

• input offset current is the difference between the two input bias currents and this leads to offset errors in in-amps when source resistances in the two input terminals are unequal.

  输入失调电流是两个差动输入端的基极输入电流，当两个输入端的源阻抗不相等时，它可引起仪表放大器的失调误差。

• for example, the model 7158 low current scanner card has offset current (typically

  例如，7158型小电流扫描卡的偏移电流小于1 pa（典型值小于30 fa）。

• r2 and r4 are chosen to minimize errors due to input offset current as outlined in the section describing the photocell amplifier.

  r2和r4用来降低因输入失调电流产生的误差，其原理与前文光电二极管放大器所述一致。

• if the offset current is relatively constant, this value can then be subtracted from subsequent measurements.

  如果偏移电流相对稳定，则可以从随后的测量值中减去该值。

• offset current is especially significant when measuring low currents if the magnitude of the offset is comparable to the low current being measured.

  在测量小电流时，如果偏移电流的幅值与被测小电流相当，偏移电流就尤其明显。

• this is done by subtracting the offset current for a given channel from subsequent measurements made via that channel.

  在通过某个通道进行测量时，则可从测量读数中减去该通道的偏移电流。

• close each channel individually and measure the offset current after allowing the switching transients to decay and the current to stabilize.

  分别关闭每个通道，并等待切换瞬态小时且电流稳定后，测量偏移电流。

• input offset current can be determined by capping the input connector and selecting the lowest current range.

  输入偏置电流可以通过盖上（capping）输入连接器并选择最低的电流量程来决定。

• offset current is a spurious current generated by a switching card even though no signals are applied.

  偏移电流是开关卡产生的杂散电流（即使没有信号时）。

• this lack of static, dc offset current in the output transformer means that the core can be made smaller, because it requires no air gap to prevent core saturation from the static dc offset current.

  这种缺乏静态，直流偏移电流输出变压器的核心手段，可更小，因为它不需要空气间隙，以防止核心饱和从静态直流偏移电流。

• once a given combination of matrix cards, sourcing, and measuring devices is put together, it may be desirable to measure the offset current for various pathways to characterize the system.

  一旦将矩阵卡、源和测量装置组合连接在一起之后，就可能希望测量不同通路的偏移电流，从而来表征系统。

• after discussing how the input offset current influences the output of operational amplifier, the optimal relationship between peripheral impedance is obtained.

  通过讨论输入失调电流对集成运算放大器输出的影响，推导出集成运算放大器外围阻抗的最佳取值关系。

• however, offset current and leakage current are the types of interference most frequently encountered and are explained further at the end of this section.

  然而，偏移电流和漏泄电流是最常见的干扰类型，并在这部分末尾进行了更详尽的说明。

• since the isolated switches on the model 7169a form c switch card remain energized during the measurement of current, any offset current from the card is irrelevant to the measurement.

  由于7169a型c型开关卡上的隔离开关在测量电流期间保持被激励状态，所有来自开关卡的任何偏移电流都与测量是无关的。

• scanner cards designed to minimize offset current are commercially available.

  商业上有专门设计的开关卡，其偏移电流非常小。

• to achieve accurate results, the offset current specification must be smaller than the signal current that is being switched.

  为了获得準确的结果，偏移电流技术指标必须小于被切换的信号电流。

• the offset current specification of the switch card should be as low as possible for switching low current.

  对于切换小电流来说，开关卡的偏移电流指标应该尽可能小。

• with an electrometer, the input offset current is very low.

  静电计的输入偏置电流是很低的。

• for example, the offset current of the relays and the leakage resisstanceof the boards, connectors, and cables may degrade the integrity of high impedance applications.

  例如，继电器的偏置电流以及电路板、连接器和电缆的漏泄电阻都可能会破坏高阻抗应用的完整性。

• offset current is the current generated by the circuit as measured at the output when no signal is applied.

  偏移电流是指在未施加信号时，被测电流在输出上产生的电流。