The continuous type photocatalysis oxidation treatment waste water device can effectively use nano-photocatalysts and light energy to treat waste water.
本实用新型能够高效利用纳米光催化剂和光能处理废水。
The results from cell compatibility experiment reveal that anodize oxidation treatment can improve the biocompatibility of titanium and its alloy.
从研究结果来看,阳极氧化表面处理将颜色单一的钛及其合金提供了多种的色彩,增强其观赏性。
In this paper was studied optimum technology parameter of the oxidation treatment in succession of the ozone gas against the surface of carbon fibers with the method of rhombic design.
本文用正交设计法研究了臭氧气体对炭纤维表面的连续氧化处理的最佳工艺参数。
Feasibility and effect of electrochemical oxidation treatment method were studied dealing with high concentrated phenolic sodium wastewater.
研究了电氧化法处理高浓度酚钠废水的可行性及处理效果。
Taking the experiment of Shengli oilfield heavy oil wastewater advanced oxidation treatment as the example, conducts the research to oily wastewater discharging technologies.
以高级氧化技术处理油田含油污水实验为例,对油田含油污水外排处理技术进行研究。
Gas-phase oxidation treatment resulted in distrihution of some micro-pores and ditches at the carbon fiber surface and led to stress concentration therefore, the composite strength was not high.
结果表明:空气氧化处理碳纤维表面形成微孔和刻蚀沟槽,容易形成应力集中,复合材料的强度不高;
The alloy after micro-arc oxidation treatment has the excellent abrasion resistance under dry sliding.
微弧氧化处理后的试样在干摩擦小滑动距离下表现出良好的耐磨性能。
By this method, an acidic solution adhered to the surface of the hot-dip galvanized steel sheet after the surface oxidation treatment can be efficiently and sufficiently washed out.
通过该方法,能够有效且充分地洗掉附着在实施表面氧化处理的热镀锌钢板的表面的酸性溶液。
Meanwhile the mechanism of the anodic oxidation treatment to improve the interfacial property of composites is obtained by analyzing the results.
同时通过实验结果分析,阐明阳极氧化处理使复合材料界面性能改善的机理。
A new technique of composite solid lubricant coating-PTFE composite coating on aluminum alloy by hard anodic oxidation treatment combined with solid lubricant of PTFE, is introduced.
介绍了一种新的复合固体润膜技术,即利用铝合金硬质阳极氧化处理技术与固体润滑剂聚四氟乙烯复合,从而形成铝合金聚四氟乙烯复合涂膜。
A furnace with preheating equipment for water vapor is developed for surface oxidation treatment of hot work dies. This type furnace is successfully used in industry.
针对热作模具钢的表面氧化处理,本文开发了一种带蒸汽预热装置的氧化处理炉,这种炉型现已应用于工业生产。
Then, oxidation treatment such as heat treatment is performed to oxidize the metal thin film partly or entirely.
然后,执行诸如热处理之类的氧化处理以部分或全部地氧化该金属薄膜。
Air oxidation treatment leads to a remarkable increase in the surface area and mesopore volume of ac samples but little change in the quantity of surface oxygen groups.
而空气氧化处理则会导致活性炭的中孔面积和孔容显着增大,但对表面含氧基团的影响较小。
The thermal conductivity performance of porous silicon and the influence such as aperture, porosity and oxidation treatment are introduced.
介绍了多孔硅的热导率特性以及孔径、孔隙率、热处理等因素对其影响。