英语释义

1. shafts or material for shafts

片语

shaft sinking[矿业] 凿井

air shaft[建][矿业] 通风井

pile shaft桩身

single shafting[机]

driving shaft传动轴；[机] 主动轴（组合器轴）

inship shafting内侧轴系

hollow shafting[机] 管轴，[机] 空心轴

diverging shafting[机]

shaft coupling联轴器；[机] 联轴节

output shaft[机] 输出轴；从动轴

shaft wall井壁砌壁；炉墻

vertical shaft[矿业][地质] 立井；[机] 立轴；立柱

main shafting[机] 主轴；总轴

gear shaft齿轮轴

shaft kiln[炉窑] 竖窑

wing shafting侧轴

drive shaft[机] 驱动轴；主动轴

inclined shaft斜井；斜坑

auxiliary shaft副轴；辅助竖井

main shaft[机] 主轴；总轴

shaft seal[机] 轴封，轴封装置；主轴密封

shaft furnace竖式炉

rotating shaft转轴；旋转轴；回转轴

shafting efficiency轴系效率

shaft lining[矿业] 井筒支护；轴包覆，竖井衬层

crank shaft曲柄轴

shafting bearing[机] 轴承；尾轴轴承；轴颈轴承

transmission shaft[机] 传动轴

英汉例句

• Rational aligning calculation of propulsion shafting in cold and warm conditions, and confirm several fitting technics parameters include of temporary supports, sags and gaps between flanges.

  在冷热两种状念下进行了轴系合理校中计算，并确定中间轴临时支承的位置、法兰间偏移与曲折值各安装工艺参数。

• The Samson is tiny moving among the vast floating islands of rock. Bansheerays and other smaller flying species circle next to the cliffs in the sunlit shafting between the clouds.

  参孙直升机在巨大的漂浮岛屿与巖石间如一粒尘埃般移动。阳光穿过云层照耀在峭壁上斑溪和其他小些的飞行动物们在峭壁旁盘旋。瀑布沿陡峭的悬崖暴跌数千英尺后溶入山底的虚无飘渺中。

• Theoretical and experimental research on steady vibration response of shipping propulsion shafting with local nonlinear characteristics are done.

  对有局部非线性的船舶推进轴系振动稳态响应进行理论和试验研究。

• And it「s proven that this program can produce accurate results and can be used for vessels」 shafting intensity calculation.

  通过验证，表明该程序计算结果精确，可用于舰艇轴系强度计算。

• According to coupling principle and excited force of shafting system, a model of coupled torsional-axial forced vibration can be constructed.

  根据刚度耦合原理，并考虑轴系强迫激励进而建立了扭纵耦合强迫振动模型。

• Centering of shafting by calculation method.

  计算法轴系校中。

• Based on calculation of the shafting dynamics model of unit, the value of unbalance mass of runner correspond to the value of vibration quantity in the testing site was obtained.

  根据建立的机组轴系动力学模型，计算得到了测试位置处振动量所对应转轮的质量不平衡量值的大小。

• A method which is used for calculating steady vibration response of shipping propulsion shafting connecting with a coupling with nonlinear hysteresis characteristics are studied.

  对有非线性迟滞特性联轴器的船舶推进轴系振动稳态响应计算方法进行研究。

• The paper gives a brief introduction to the shafting coupling design and its features for a fast attack craft.

  本文简要介绍了轴系联轴器的设计及其特点。

• Static error mostly includes shafting error, coder error, time-lag error by TV sensor, measure distortion by optics structure and atmosphere refraction error etc.

  静态误差主要有轴系误差、编码器误差、电视传感器本身存在的时间滞后误差、光学结构中可测量的失真以及大气折射误差等；

• The characteristics of error motion of shafting is a complex signal which includes periodic component and random term.

  轴系回转误差运动的特征是一项复合信号，它含有周期分量和随机分量。

• The effect of elastic coupling on wobble plate piston engine shafting vibration in the underwater craft was discussed principally.

  本文主要讨论在某水下航行装置中，弹性联轴节对摆盘式活塞发动机轴系振动的影响。

• An optimum adjustment is investigated of the shafting dynamic location of a large-sized turbogenerator unit.

  本文研究了大型汽轮发电机组轴系动态位置的最优调整。

• It constructed the math model of the ship shafting transverse vibration and the lubricative capability calculation of stern tube bearing.

  分别构建了船舶轴系横向振动和船舶尾管轴承润滑性能计算的数学模型。

• The guide bearing lubrication performance of hydropower sets is directly relative to the problems of shafting abrasion and vibration.

  水轮机导轴承的润滑性能直接关系着整个机组轴系的磨损与振动问题。

• In this paper, an improved dynamic substructures method is described. The problem of torsional vibration of diesel complex shafting is analysed with this new method.

  本文给出了一种改进的动态子结构法，并用该方法分析内燃机复杂轴系扭转振动问题。

• By the use of a finite element method and by taking account of the non-linearity of bearing oil film force established are the shafting nonlinear equation group of the said turbogenerator.

  用有限元法及考虑各轴承油膜力非线性，建立了大型汽轮发电机组轴系非线性方程组。

• And the correctness of the above analysis has been proved by the quantitative calculation with the unbalanced response program of shafting and tests on a model rotor.

  并且应用轴系不平衡响应程序进行定量的计算和通过模型转子试验验证了以上分析的正确性。

• This paper presents the dynamic alignment calculation of Controllable-Pitch Propeller (CPP) propulsion shafting based on the improved three-moment equation.

  采用基于改进的三弯矩方程进行调距桨推进轴系的动态校中计算。