片语

shrink k fit热配合

shrink-fit vessel缩合式容器

shrink on fit冷缩配合

HSK thermal shrink-fit cutterHSK热装式刀具

Shrink to Fit Cream产后消脂纤体霜

shrink to fit压缩至适当尺寸

Lengthened Shrink-fit Holder热装式加长刀桿

Shrink To Fit Cellulite Cream瘦身霜

英汉例句

• The third shrink fit (10) allows greater torques to be transmitted from the gear (4) to the shaft (2) than the first shrink fit (8) and smaller torques than the second shrink fit (9).

  通过第三热压配合部（10）能够将比通过第一热压配合部（8）更大的转矩和比通过第二热压配合部（9）更小的转矩从齿轮（4）传递到轴（2）上。

• An engine accident by slipping of shrink fit crankshaft which caused severe damage of two main bearings is analyzed.

  对主机曲轴红套滑移，并使二道主轴承严重损坏的机损事故进行了分析。

• The relative sizes of the turn down rims of the fins were determined for the processing characteristics of square finned tubes, the shrink fit technology program of the casing fin tubes was proposed.

  针对方形翅片管加工特点，确定了翅片翻边的相关工艺尺寸，提出了套片式翅片管的热套工艺方案。

• Detailed information on the shrink fit process in laboratory and the experiment data using a full-scale gear-axle piece are...

  详细叙述了原尺寸试件过盈联接承载能力的试验方法和试验结果，得出了配合面间摩擦系数的经验公式。

• Through analyzing finite element in shrink fit, the application of the contact element in shrink fit is discussed.

  通过对过盈装配的有限元分析，研究接触单元在过盈连接中的作用。

• The test method employed is non-destructive, so that only one model is needed for investigating stresses in a rotating disc at various speeds, and for determining the static shrink fit stresses.

  由于这是一种非破坏试验方法，所以仅一个模型就可以对几种不同转速以及静过盈状态下的应力进行测定。

• The cylindrical surface shrink fit process to match large gears and their axles is practised in the manufacture of large electro blocks HC8 and HC16 now under development.

  本文在研制的HC8和HC16大型电动葫芦中，大齿轮与轴之间采用了圆柱面过盈联接。

• The transfer matrix across the shrink fit section is established.

  本文导出了热套段模型的传递矩阵表达式。