片语

acidic silica sol酸性硅溶胶

silica sol precursor硅溶胶前体

nano silica sol纳米sio

silica sol binder硅溶胶粘结剂

ludox硅溶胶

Silica Sol Mold Shell硅溶胶型壳

silica sol shell mold硅溶胶制壳

modified silica sol改性硅溶胶

silica sol slurry硅溶胶

英汉例句

• the process and mechanism of solidification of wollastonite silica sol slurry are studied.

  研究了硅灰石硅溶胶浆体的固化过程及机理。

• modification effects of the silica sol on the bentonite calcined at 500℃ are better.

  硅溶胶改性500℃焙烧后膨润土的性能更好。

• a low cost interior wall coatings has been developed, which is formulated based on styrene/acrylic emulsion and silica sol as binder and mixed with bentonite, pigments and fillers and additives.

  以苯丙乳液和硅溶胶为主成膜物 ，膨润土为辅助粘结剂 ，加入适量的颜填料及助剂配制低成本内墻涂料。

• silica sol without ethanol was prepared with tetraethyl orthosilicate(teos) as precursor.

  以硅酸乙酯（teos）为水解前驱体，制备了有机硅水溶胶体系。

• in this paper, the equipment of polysulfone ultrafiltration membranes for silica sol concentration is introduced.

  本文叙述了聚矾超滤膜装置在硅溶胶浓缩上的应用状况。

• dry stock of silica sol ceramic mold was prepared by the colloidal molding technique and optimized vacuum drying process.

  采用胶态成型技术和优化的真空干燥工艺制备硅溶胶陶瓷型干坯料，并探讨焙烧工艺对其收缩率和抗压强度的影响。

• in addition, a polymer of a resin formed article etc. obtained by curing a monomer-dispersed silica sol may be deteriorated, degraded, or the like with time.

  另外，使单体分散硅溶胶固化而得到的树脂成型体等的聚合物随时间发生变 性、分解等。

• polyurethane templates are treated using silica sol to improve the coherence between the slurry and the surface of templates and the surface coarseness.

  以硅溶胶为表面改性剂，从提高与水基浆料的相容性、增加表面粗糙度入手，对有机模板进行了表面处理。

• a review of preparation principle of gel and sol and preparation method of silica sol and application of gel and sol technique on textiles is surveyed.

  综述了溶胶凝胶的制备原理及硅溶胶的制备方法，概述了目前溶胶凝胶技术在纺织品上的应用情况。

• in order to improve the performance of epoxy resin e-44, it was modified with silica sol through direct ring-opening reaction.

  采用硅溶胶与环氧树脂e-44直接开环反应的合成方法改进环氧树脂的性能。

• the present investigation is focus on the preparation process of silica-based ceramic mold using silica sol as binder.

  主要研究了以硅溶胶为粘结剂的硅基陶瓷型制备工艺。

• preparation and usage of polyvinyl formal modified with polyacrylate and silica sol are introduced.

  介绍了一种用聚丙烯酸酯和硅溶胶改性聚乙烯醇缩甲醛的制备方法和用途。

• coagulation quick drying mechanism for quick-dry silica sol ceramic shell was analyzed by comparison between the stability and structure on common silica sol and quick-dry silica sol.

  通过普通硅溶胶和快干硅溶胶的结构与稳定性比较分析快干硅溶胶陶瓷型的胶凝快干机理。

• a high-performance and noncombustible organic-inorganic composite coating applied on aluminum alloys was prepared by using an as-synthesized, water-borne modified silica sol by organic silanol.

  以合成的水性有机硅改性硅溶胶为基料，在铝合金表面制备了一种具有良好理化性能的不燃有机-无机复合涂层。

• the composite silica microsphere was obtained through the polymerization of urea and formaldehyde occurred in the silica sol that prepared from the hydrolyzation of tetraethyl orthosilicate.

  以甲醛与尿素作为单体在正硅酸乙酯水解所得的氧化硅溶胶中进行聚合反应制得了有机—无机二氧化硅复合微球。

• the use of alcoholic ethyl silicate would be restricted and the silica sol would be more and more extensive because of the more strict environmental protection requirement.

  由于环保要求的提高，醇基硅酸乙酯的使用受到限制，硅溶胶的应用越来越广泛。

• the fixing and darkening effects on direct black gf treated by aqueous silica sol were also discussed in this paper.

  本论文对硅的水溶胶用于直接黑gf的固色和增深处理进行了探讨。

• silica sol is a kind of colloid solution well dispersing corpuscles of silicon dioxide in water.

  硅溶胶是二氧化硅的微粒分散于水中的胶体溶液。

• the preparative process of silica sol with natural wollastonite belonged to first origination, natural resource was used, low cost and good economic benefit were obtained.

  得出了天然硅灰石制备硅溶胶工艺属首创，能够利用天然资源，成本低，经济效益好的结论。

• the requirements for silica sol and refractory powder for mold shell in face layer differ from that in back layer.

  硅溶胶型壳的面层和背层对硅溶胶和耐火粉料的要求是不一样的。

• the silica sol is a kind of colloid solution, silica drop dispersing in water or solvents.

  二氧化硅溶胶是二氧化硅微粒分散于水中或有机溶剂中的胶体溶液。

• and the silica sol prepared in lab and used in microelectronic industry is purified to 10~-6. the purification mechanism is discussed.

  然后对实验室制备的或在工业中已有应用的硅溶胶进行纯化，使其纯度达到10-6级，并探讨了其纯化机理。

• it was shown that the yield value of colloidal silica sol slurry was increased and its suspensibility was improved by adding some additives.

  试验结果表明，加入添加剂可提高硅溶胶涂料的屈服值，改善涂料的悬浮性；

• in this paper, the property of silica sol was described, and various conditions of preparation of silica sol with natural wollastonite were examined and demonstrated.

  首先对硅溶胶的性能进行了叙述，并对天然硅灰石法制备硅溶胶的各种条件进行较详细的考察和论证。