英语释义

1. to heat (a vapor not in contact with its own liquid) so as to cause to remain free from suspended liquid droplets
superheated steam

2. to heat (a liquid) above the boiling point without converting into vapor

3. the extra heat imparted to a vapor in superheating it from a dry and saturated condition also the corresponding rise of temperature

片语

minimum superheat最小过热度

superheat limits过热极限

wall superheat壁面过热度

zero superheat零点过热

superheat treatment过热处理

superheat phenomena过热现象

superheat system过热系统

degree of superheat[热] 过热度；过热程度

Discharge Superheat排气过热度

英汉例句

• molten melt superheat treatment is an effective means for microstructure refinement and advancement of alloy mechanical property.

  熔体过热处理是细化组织提高合金力学性能的有效途径。

• heat flux of superheated liquid steel delivered to the shell surface increases in direct proportion to the casting speed and superheat temperature, respectively.

  过热钢液传递到凝固坯壳表面的热流量与拉速和过热度的增加成正比；

• maximum wall superheat does not always exist at the top of the boiling surface.

  壁温过热度沿高度分布存在极大值，且该极值并不总在通道顶部；

• superheat treatment can change state of the melt obviously, consequently affects the final structure and properties.

  熔体过热处理改变了熔体的结构状态，从而影响了最终组织及性能；

• for the security and economic of power plant, research the new control method which can overcome the disadvantages of traditional superheat steam temperature control system has important meaning.

  研究能克服传统过热汽温控制系统的缺点的新型控制方法，对于电站运行的安全性和经济性有十分重要的意义。

• it will not superheat the floor.

  不会使地面过热。

• on this basis, by using logical cooling means and superheat protect means, we design and implement a uhf broadband solid-state high power amplifier.

  以此为基础，利用合理的散热设计和过热保护电路，设计并实现了一套uhf宽带固态大功率放大器。

• the experience was conducted using cooling slope and low superheat processes, effects of pouring temperature and the degree of slope on the billet's structure were researched.

  采用激冷斜槽法和低过热法进行浇注料坯的试验，在试验中研究了不同浇注温度和冷却板倾斜角度对所浇注料坯的微观组织的影响。

• the pivotal factors, pressure of atomization gas, rotation speed of turnplate and degree of superheat of the melted aluminium, are analysed in detail.

  对活化过程中影响活化铝粉性能尤其是粒度性能的各种因素如雾化气体压力、转盘转速、金属熔体过热度等进行了实验研究。

• using developed dynamic drop technique(floating droplet method), we measured the limits of superheat of n-pentane and n-heptane, n-nonane systems of binary n-alkaline mixtures.

  采用发展的动态液滴技术（悬浮液滴法） ，测定了正戊烷与正庚烷、正辛烷、正壬烷二元混合物的过热极限温度。

• it is found from the result of calculation that when casting speed is constant, superheat and intensity of cooling have remarkable influence on the front edge of solidified shell.

  根据模拟计算结果发现，在拉速一定的条件下，过热度和冷却强度对钢液的凝固前沿有着显着的影响。

• a new hypothesis is proposed in the paper to determine the superheat limit of liquid on the basis of fluctuation theory of statistical thermodynamics.

  本文利用统计热力学涨落理论提出一个新的假说，并由此建立了确定液体极限过热度的新方法。

• in the superheat cycle, the saturated dry steam leaving the boiler drum is further heated before entering the turbine.

  在过热的循环过程中，离开锅炉汽包的干饱和蒸汽在进入汽轮机前被进一步加热。

• the step response method of the outlet superheat of evaporator is measured by conducting experiments, and dynamic model of eev is established by lse(least square estimation).

  通过阶跃响应实验法，利用最小二乘法建立燃气机热泵蒸发器—电子膨胀阀系统的过热度响应动态模型。

• the influence of suction gas superheat on the performance of the compressor is analyzed.

  分析了吸气过热度对压缩机性能的影响，并对经验关系式进行了修正。

• furthermore, casting speed, superheat and cooling waters effects on steady temperature field are analyzed in this paper.

  此外还分析了拉速、过热度和冷却水量等因素对稳态温度场的影响。

• the heated steam is then fed through the reminder of the turbine before being condensed. the reheat cycle incorporates an improvement in thermal efficiency over the superheat cycle.

  被加热后的蒸汽在被凝结前通过汽轮机级。再热循环在热效率方面比过热循环有了改善。

• this superheat cycle was chosen to have the same turbine exhaust conditions as the previous rankine cycle.

  过热循环被选择为和先前的朗肯循环具有相同的汽轮机排汽条件。

• the clean hot gases then enter the boiler superheat section as was before the retrofit.

  此时洁凈热煤气在锅炉改良之前进入过热段。

• with the suction superheat kept constant meantime, the valve opening, refrigerant mass flow rates and the cooling capacity between two individual units exhibit a parabola relationship.

  若同时保持吸气过热度一定，则三联式系统内两单机的膨胀阀开度、制冷剂质流量、制冷量呈现出抛物线的依变关系；

• it is shown that the degree of superheat of molten steel and the deoxidation alloying are main factors for the formation of skin blowhole.

  明确了钢液的过热度及脱氧合金化是铸坯产生皮下气泡的主要影响因素；

• there easily exists shrinkage porosity due to superheat of ingate root in large plain parts investment casting.

  大平面铸件常在内浇道根部出现过热，在该处产生缩松缺陷。

• lastly the adaptive fuzzy control method proposed in the paper is applied to control the superheat steam temperature of the boiler, and the practical control effect is satisfactory.

  论文最后将文中的自适应模糊控制方法应用到锅炉过热蒸汽温度控制中，取得了良好的控制效果。

• besides the cell voltage, bath temperature and bath ratio, the inputs of the system also include the liquidus temperature, superheat extent and cathode voltage.

  系统的输入参数除传统的电压、温度和分子比外，还采用初晶温度、过热度和阴极压降等作为系统的输入参数。