dead time中文,dead time的意思,dead time翻译及用法

2025-09-06 22:28 浏览次数 8

dead time

英[ded taim]美[dɛd taɪm]

停滞时间;窝工时间

dead time 英语释义

英语释义

    1. the short interval which is required for a counting tube to recover its sensitivity after any one discharge and during which it is incapable of further response

    2. the time lag between a stimulus given to an instrument and the resulting response

    3. downtime sense 2a

dead time 片语

片语

loss dead-time无感时间损失

Dead In Time死亡时间

Dead Band Time不感应带调整时间

dead-time compensation死区时间补偿

dead-time correction死时间改正

dead-time delay纯时滞

dead reckoning time已推算时间

error dead-time无感时间误差

Dead on TimeDead on Time is a 1983 British short film directed by Lyndall Hobbs and written by Richard Curtis and Rowan Atkinso The film is a comedy which tells the story of Bernard Fripp (Rowan Atkinson) a man who, on attending a routine check-up, is diagnosed by his doctor (Nigel Hawthorne) as having a rare disease leaving him only 30 minutes to live.

dead time 例句

英汉例句

  • podcasting allows people to make far more effective use of their travel - what might have been dead time becomes valuable reflective time.

    播客允许人们可以更有效的利用他们旅途的时间,那些曾经是没用的时间如今变成了有效的反思时间。

  • for nuclear spectrum measurement in nuclear analysis, the correction of dead time in multi channel pulse amplitude analyzer must be considered.

    针对这种情况,探讨了两种有效的死时间修正方法。

  • the influence of dead time of power device igbt on inverter「s output current and output voltage is discussed.

    分析了变频器主功率器件igbt的死区时间对其输出电压、输出电流的影响。

  • in this paper, a new method is proposed to compensate dead time using phase angle prediction, and current sensor can be omitted.

    提出一种用相位角预测的方法实现逆变器和变流器死区时间的补偿,从而可省去电流传感器。

  • the uncertain object with dead time is taken as a reference model and a kind of adaptive rule is proposed to make parameters of the compensator to approach the object′s.

    以线性大时滞不确定被控对象为参考模型综合出自适应律,使预估补偿器的参数逐步逼近被控对象的参数直至相等。

  • to modify the original camac data acquisition system in high energy physics experiment with vme can increase the data acquisition speed and reduce dead time of system obviously at a small expense.

    在高能物理实验数据获取系统中使用vme改造原有camac系统可以在花钱不多的前提下显着提高数据获取速度,减少系统死时间。

  • in many cases, allan variance has to be measured with dead time and then modified with barnes bias function.

    在很多场合只好用有间隙采样做阿侖方差,然后用巴勒斯偏函数加以修正,其繁杂程度是可想而知的。

  • the dead time control in spwm converter increases the harmonic component in voltage output and decreases the voltage utilization and reliability of converters.

    spwm变换器中的死区设置使变换器输出电压谐波含量增加、电压利用率和可靠性降低。

  • the principle of this method is introduced in detail, and a kind of circuit of generating dead time and its timing simulation are given.

    详细叙述了该方法的基本原理,并以其中的一个死区时间产生电路为例,介绍了电路的设计要点及时序分析。

  • two methods to calculate the dead time of the second dimension were introduced.

    建立了两种恒压模式下全二维气相色谱第二维死时间的测定方法。

  • a modified dead time compensation method was used to obtain better output voltage waveforms.

    采用了改进的死区效应补偿方法以获得理想的输出波形。

  • a problem, which causes the biggish detector dead time during the biggish power experiments, is discussed. a method used for dead time correction is found.

    对于在放射性核素测量中可能遇到的较强源带来的较大探测器死时间问题进行了研究,找到了进行死时间修正的方法。

  • by knowing what」s important to you and making the most of your dead time you change your life dramatically.

    知道了对你重要的事情以及该如何利用大部分停滞时间,你可以让你的生活得到巨大改变。

  • unreasonable selection of dead time can make inverting components to produce higher inrush voltage and current and even damaged.

    死区时间选择的不合理会使逆变器件产生过高的浪涌电压和电流甚至损坏。

  • it is shown that the gate-pulse mode reduces the dead time and improves the count rate.

    测试结果表明,有源门控模式可以有效缩短死时间并提高计数率。

  • exploration early in strategy games also fills dead time when you「re waiting to build your base and army, so it fills a secondary need.

    在战略游戏中,早期的探索在等待建立基地和军队的时,也填补了死亡时间,这也填补了次级需要。

  • the dead time was when we were controlled by ego.

    而「死时间」正是我们被自我所束缚的时候。

  • to record the lost pluses and make up the amounts of the lost pluses is an effective method to treat with dead time in signal peak analyzer system.

    用计数的方法解决脉沖幅度分析器系统的谱峰幅度损失问题,然后根据丢失脉沖的个数进行补偿是解决幅度分析系统中死时间问题的有效方法。

  • but in practical measurement, it is very difficult to make no dead time sample due to the counter」s dead time.

    但实际测量时由于计数器的死区时间,使得无间隙采样十分困难。

相关热词