film thickness中文,film thickness的意思,film thickness翻译及用法

2025-09-07 04:16 浏览次数 9

film thickness

英[film ˈθɪknɪs]美[fɪlm ˈθɪknɪs]

(油)[物化] 膜厚度

film thickness 片语

片语

film phonograph thickness measuring膜厚测定法

film phonograph thickness薄膜厚度

film material thickness薄膜厚度

film phonograph thickness meter膜厚计

film coating thickness薄膜包衣厚度

film phonograph thickness monitor膜厚计

film-thickness controller控制仪

film thickness 例句

英汉例句

  • as the film thickness increases with temperature and time, cracks appear and further oxidation of aluminium alloys is possible .

    作为膜厚度随温度和时间、裂缝的出现和进一步氧化铝合金是可能的。

  • the mechanism of phase transition temperature of film changing with film thickness is explained by the influence of gibbs free energy on phase transition.

    进而根据界面能对相变温度的影响,对钛酸铅薄膜的相变温度随薄膜厚度的变化规律进行了解释。

  • the film thickness is directly proportional to the resistance of the deposited coating.

    涂膜的厚度直接与沉积涂层的电阻成正比关系。

  • film thickness — are all layers in the film (color) bringing the image into focus.

    胶片厚度---决定影像是否在各个(颜色的)感光层正确聚集。

  • in this paper, a probe of vacuum microbalance to monitor and measure for high accuracy of film thickness is introduced, thermostatic probe of the semiconductor refrigeration device.

    本文研制了一种用于高精度膜厚监测的真空微量天平探头:半导体致冷器件恒温探头。

  • the mass transfer equation was introduced into heat transfer model of falling film evaporation. the radial velocity, mass diffusion coefficient and variation of film thickness were taken into account.

    将传质方程引入到垂直管降膜蒸发传热模型中,求解时考虑了径向速度、质量扩散系数和膜厚变化对传热的影响。

  • a theoretical formula for computing the film thickness in line contact ehl problems is derived.

    给出了一种线接触弹流问题中油膜厚度的理论计算公式。

  • current density: unit under the plating area under current, usually the higher current density film thickness is thicker, but is high coating will scorched thick dry.

    电流密度:单位电镀面积下所承受的电流,通常电流密度越高膜厚越厚,但是过高时镀层会烧焦粗燥。

  • the results show that there are obvious changes at film pressure distribution, maximum film pressure, film thickness distribution and minimum film thickness when there is misalignment.

    计算结果表明,轴颈倾斜时,轴承油膜压力分布、最大油膜压力、油膜厚度分布和最小油膜厚度等都有明显的变化。

  • the optimum water film thickness of slipper in water hydraulic axial piston pump were caculated and analyzed.

    对纯水轴向柱塞泵滑履摩擦副的最佳水膜厚度进行了计算和分析。

  • the national standards for film thickness testing methods are introduced.

    介绍了国家标準关于漆膜厚度的测试方法。

  • electroplating uneven thickness: refers to the actual plating out when the film thickness in high and low, or uneven distribution.

    电镀厚度不均:指实际镀出膜厚时高时低,或分布不均。

  • the controlled speed determines film thickness and overall coating efficiency, and its surface finish determines the texture of the coating.

    速度的控制决定薄膜的厚度和整体涂布的效率,并且表面的光滑决定涂层的手感。

  • the influence of speed, energy of solid surface, slide ratio, lubricant viscosity and chemical property, etc. on film thickness in thin film lubrication are discussed.

    讨论了速度、固体表面能、滑动比、润滑剂粘度和化学性能对薄膜润滑状态下油膜厚度的影响,以及弹流润滑向薄膜润滑转化条件和液体膜失效条件。

  • the quantity conditions of film thickness and refractive index control were acquired. the basic facture technics of branched pmps waveguide circuit was established.

    实验归纳了支化聚甲基苯基硅烷薄膜的光折变规律,获得了控制薄膜厚度和折射率的定量条件。

  • by this model, the effects of adsorption time, concentration of chloroform in drinking water and film thickness on the adsorption efficiency were discussed.

    应用此模型研究了萃取时间、水样中氯仿的本底质量浓度和高效有机吸附膜厚度等对萃取效率的影响。

  • electroplating position: in a location in the plating liquid, and the relative position of the anode, can affect the film thickness distribution.

    电镀位置:镀件在药水中位置,与阳极相对位置,会影响膜厚分布。

  • it can measure the oil film thickness, oil temperature, crank angle, speed, journal center locus and minimum oil film thickness of main bearing in diesel engine.

    该系统可测量内燃机主轴承的油膜厚度、油膜温度、曲轴转角、转速、轴心轨迹和最小油膜厚度。

  • it also represents the influences of aluminum film thickness on blazed efficiencies of the ruling diffraction gratings and provides proper ranges of the thickness factors.

    实验研究了铝膜厚度对衍射光栅闪耀效率的影响,给出了铝膜厚度系数的最佳范围。

  • the results indicated that the sealing parameters changed remarkably near the opening critical film thickness in the start up process.

    研究表明,启动过程中,密封的特性参数在开启临界气膜厚度附近快速变化;

  • wet film thickness gauges may be used during coating to ensure correct coating thickness.

    在涂敷时应采用湿膜测厚仪以确定準确的涂层厚度。

相关热词