英语释义

• a projection used for strength or for attaching to another object

片语

flange mounting凸缘式安装件

top flange上翼缘；上凸缘

connecting flange连接法兰；联接凸缘

bottom flange下翼缘；下阀盖

welding neck flange[机] 对焊法兰

flange motor凸缘型电动机；凸缘底座电动机

flange thickness[铁路] 轮缘厚度；法兰厚度

wheel flange[车辆] 轮缘，轮凸缘

loose flange活套法兰

flange joint凸缘接合

flange steel凸缘钢；弯边钢

flange width法兰宽度；[机] 凸缘宽度；轮级宽度

flange plate凸缘板

flange connection法兰接头；法兰联接；凸缘联接

casting flange铸造凸缘

bolted flange栓结法兰；联接法兰；螺栓结合凸缘

blind flange盲板；堵塞法兰

FLANGE TYPE[机] 法兰类型

英汉例句

• replacement sleeves are made with one flange end slightly softer than the other.

  用来更换的套管其一端的法兰比另一端稍微柔软一些。

• refer to table1 for flange classifications and serial parameters.

  法兰分类及系列参数见表1的规定。

• then, use the aquarium silicone to seal under the flange around all 4 screw holes and around the pipe hole and screw it down with 4 short wood screws.

  接着，用水族箱硅胶把法兰盘底、四个螺丝孔以及管孔周围全都涂抹上，然后鉆入四枚木螺钉固定好。

• unscrew the nut that connects the drain to the flange using an adjustable wrench if you are replacing the pop-up drain. then remove the drain flange from the t-connector.

  如果你想替换弹出式排水管，你可用可调式扳手拆除连接排水管和法兰的螺丝，然后从t型三通处拆掉排水法兰。

• the large anticorrosion flange can be divided into pushing, pressing, forging, casting and so on.

  大型防腐法兰以制作方法划分可分为推制、压制、锻制、铸造等。

• the elbow shall be bolted to the floor of the wet-well and be so designed as to receive the pump connecting flange without the need for any bolts, nuts or clamps.

  弯头应该用螺栓固定在湿井地面，并且设计成具有不需要任何螺栓、螺母或皮带即可连接泵设备的连接法兰的能力。

• flange welding should rest on the reliable welding craft appraisal to guarantee the welding quality.

  法兰的焊接应依据可靠的焊接工艺评价，以确保焊接质量。

• note: you may increase the torque on the rubber sleeve up to two times the specified value without causing sleeve or flange damage.

  注意：在橡胶套管上增加的扭矩可以达到规定扭矩值的两倍，在此时仍然不会对套管或法兰造成损害。

• if you can’t unscrew the drain flange from the t-connector, use a reciprocating saw with a metal-cutting blade and cut the drain assembly away just above the t-connector.

  如果你不能从t型三通处拆掉法兰，可用金属锯片将t型三通上方的部分锯掉。

• insert two bolts of specified size (table 1) to secure the halves of the flange adapter to the valve body (fig. 2).

  插入两个特定尺寸的螺栓（表1），将法兰适配器的两半固定到阀体上（图2）。

• here need explanation is flange gaskets for the influence of choice.

  这里需要说明的是法兰情况对垫片选择的影响。

• 「the real revolution with oscar is [that] we have put a piece of metal and a flange into which skin grows into an extremely tight bone,」 fitzpatrick told bbc news.

  菲茨帕屈克告诉bbc新闻台：「我们给奥斯卡嵌入的金属与外缘装置，在其上皮肤能够生长成极其坚固的骨质，这正是给奥斯卡的假肢技术的真正突破所在。」

• allow the sleeve flange to return to its original position.

  允许套管法兰回到它的初始位置。

• to release bladder from opposite end, remove all nuts from flange and then take off cover plate.

  为了将内胆从另一边分离开来，就要从法兰上拆卸所有螺母，然后拿走盖板。

• where misalignment between the inner and outer rings exceeds 1 minute of arc, the action of the load on the flange changes considerably.

  内圈和外圈之间的不对中超过1分弧时，作用在法兰上的载荷会发生相当大的变化。

• an o-ring located in nacelle flange is applied between the grease channels in nacelle and bearing.

  在机舱润滑油脂通道和轴承之间有o形圈，o形圈位于机舱法兰上。

• flange surface roughness of the influence, especially sealing effect when using the soft cushion, seal surface coarse degree value big is the main reason for the cause of the leak of one.

  法兰表面粗糙度对密封效果影响很大，特别是当采用非软质垫片时，密封表面粗糙的度值大是造成泄露的主要原因之壹。

• flange surface roughness of the influence, especially sealing effect when using the soft cushion, seal surface coarse degree value big are caused by the leak is one of the main reasons why.

  法兰表面粗糙度对密封效果影响很大，特别是当采用非软质垫片时，密封表面粗糙的度值大是造成泄露的主要原因之一。

• then apply a rope of plumber’s putty to the underside of the drain flange and press it into the drain hole.

  在排水管法兰下方填上一卷腻子并把法兰压入排水孔。

• the flange also ensures that there will always be some water left in the tank (about half an inch) to prevent the black plastic from melting.

  法兰盘的高度应该有半英寸，以确保水箱总能存有一定的水，使黑色塑料膜不至于熔化。

• if you can't unscrew the drain flange from the t-connector, use a reciprocating saw with a metal-cutting blade and cut the drain assembly away just above the t-connector.

  如果你想替换弹出式排水管，你可用可调式扳手拆除连接排水管和法兰的螺丝，然后从t型三通处拆掉排水法兰。

• bp began trying saturday afternoon to remove the bolted top flange that only partially completed the seal with the old cap.

  英国石油公司在星期六下午开始尝试拆除用来固定旧防漏帽的法兰，这种旧的防漏帽不能充分实现堵漏功能。