片语

loose-flange joint松套法兰盘接头

flange butt joint卷边对接接头

flange weakening type joint翼缘削弱型节点

choke-flange joint扼流凸缘接头

screw flange joint螺钉凸缘接头

flange e joint凸缘接头

Flange of Universal Joint万向联轴器法兰

edge-flange joint卷边接头

flange joint detail法兰盘联轴节

英汉例句

• in order for the flange joint to maintain a gasket seal.

  为使法兰连接保持良好的垫片固定密封。

• the method of surfacing welding sealing strip was adopted to repair the deformation of the flange joint surface of the high and intermediate pressure outer casing .

  修理前，围绕兼顾解决焊接性、应力和变形问题，结合实际施工条件制定了以手工钨极氩弧焊、镍基焊丝、焊前低温预热、焊后锤击焊缝为要素的冷堆焊工艺。

• under certain pre - tension from flange joint bolt, leakage of flange sealing had an obvious decrease, thus resolving sealing failure in cover flange of heat exchange.

  在一定法兰连接螺栓预紧力作用下，法兰密封泄漏明显减少，从而解决了热交换器封头法兰密封失效的问题。

• in this article, the reform of the flange joint at the bottom of lpg tank was introduced, and the methods to remove leakage were discussed as well.

  介绍了液化石油气贮罐根部法兰组合改造情况，并探讨根除泄漏的方法。

• if there is leakage at the flange face-seal only, further tightening of bolts will almost never stop any flange joint leak.

  如果泄露仅仅出现在法兰面密封上，进一步的螺栓紧固基本上并不会阻止法兰连接部分的泄漏。

• the paper describes the common structure and some existing problems of flange joint on mill's cylinder, and the influence on manufacture organization.

  较详细论述了磨机筒体缗法兰联接常见结构及存在问题，以及对生产组织的影响。