片语

glass s bead玻璃球

hollow glass-bead空心玻璃微珠

Glass Eye Bead蜻蜓眼式玻璃珠

Glass s bead blast玻璃珠喷沙处理

glass glass bead玻璃珠

glass pendant bead琉璃吊咀

Glass impact bead spray chamber玻璃撞击球雾化室

glass bead slippers玻璃珠拖鞋

英汉例句

• the filling content of hollow glass bead generally is between 5% -20%.

  空心玻璃微珠的填充量一般在5%-20%之间。

• the treatment of hollow glass bead by silane coupling agent kh-550 and ester titanate coupling agent is introduced.

  介绍了用硅烷偶联剂（kh-550）与钛酸酯偶联剂处理空心玻璃微珠的方法；

• the flowability of hollow glass bead filled polypropylene (pp/hgb) composites were investigated at temperature 190℃-230℃ by means of melt flow indexer.

  应用熔体流动速率测定仪，于190℃-230℃下考察了中空玻璃微珠填充聚丙烯（pp/hgb）复合材料的流动性能。

• the effects of glass bead content and its size on the elastic tensile modulus (e) of the filled low density polyethylene (ldpe) composites are studied.

  研究了填充低密度聚乙烯中玻璃微珠含量及其大小对复合体系拉伸弹性模量e的影响。

• the dynamic mechanical properties of glass bead filled ldpe composites were iivestigated by using of a dynamic mechanical analyzer.

  应用动态力学分析仪，考察了低频条件下玻璃微珠填充ldpe复合材料的动态力学性能。

• the notices about the glass bead used in mechanical plating were summarized, such as avoiding the pollution of glass beads, choosing proper mixed glass beads and addition.

  总结了机械镀锌生产中玻璃珠介质使用的注意事项，主要有避免玻璃珠的污染、选择适当的混珠和恰当的加入量。

• glass bead filled with pp and pe are pseudoplastic fluid system.

  玻珠填充pp、pe体系符合非牛顿流体流变行为的指数定律。

• besides this paper discusses the sorting principle of micro diameter glass bead and brings forward sorting roundness with motion resistance and knocked-on reflection principle.

  此外，还讨论了作为準流体的微径玻璃珠分选原理，提出可通过运动阻力和平面撞击反射原理相结合筛分得到圆形微径玻璃珠。

• the performances of different impact media were compared. the results show that the glass bead is the best choice of impact media for mechanical plating.

  对比了不同种类沖击介质的物化特性，指出玻璃珠是机械镀锌沖击介质的最佳选择。

• the influence of small grain size glass bead (gb) on the properties of linear low-density polyethylene ( lldpe) was studied.

  研究小粒径玻璃微珠的粒径和用量对线形低密度聚乙烯（lldpe）性能的影响。

• glass bead gels need not be hydrated prior to use.

  玻璃珠凝胶在使用之前不需要水化。

• this hand blown glass bead has blue and white swirled flowers.

  这手吹玻璃珠有蓝色和白色的花朵众说纷纭。

• it introduces some problems that require attention during the design of different glass bead profile, and relative solving methods are carried out.

  本文着重介绍了不同的压条在设计中应该注意的各种不同问题及解决方法。

• the modified glass bead can be used in electromagnetic shielding or microwave absorbing materials, and the applicationareas are widened. the application prospects were also analyzed.

  改性后的玻璃微珠可应用于电磁屏蔽和吸波材料的制备，拓宽了其应用范围，并分析了其应用前景。

• ultrafine hollow glass bead (gb) can markedly increase the loss factor of rubber but little effect on the rubber viscosity.

  超细的空心玻璃微珠（gb）对橡胶的粘度无明显影响，但提高了橡胶的损耗因子；

• the friction coefficient of glass bead filled composite was decreased, wear resistance of the composite was increased, adhesive wear and abrasive wear were main wear behaviors.

  结果表明：加入玻璃微珠的复合材料的摩擦因数降低，耐磨性提高，其磨损行为主要是粘着磨损和磨粒磨损；

• the stirring, the glass bead breaker, the high pressure cell cracker and the high pressure cracker to break cell for releasing aldh were investigated and compared.

  本文着重考察了搅拌粗提、珠磨破碎、高压细胞破碎仪和高压破碎仪的细胞破碎方法对释放aldh的影响。

• the cell structure, compression and damping properties of rigid polyurethane foam filled with hollow glass bead were studied.

  研究了加入空心玻璃微珠后，硬质聚氨酯泡沫塑料的泡孔结构、压缩性能以及阻尼性能。

• the round rate of this kind of glass bead are as high as 90% with very low impurity.

  此类玻璃珠的成圆率高达90%以上，杂质含量极低。

• the results showed that the compatibility of hollow glass bead and resin was improved by adding silane coupling agent.

  结果表明，硅烷偶联剂改善了空心玻璃微珠与树脂基体的相容性。

• a conductive and anticorrosive coating was synthesized with modified epoxy resin as bonding agent and silver-coated glass bead as conductive filling.

  以改性环氧树脂为黏结剂、银包玻璃微珠为导电填料合成了导电防腐涂料。