片语

tie bolt[机] 系紧螺栓，枕木螺栓；连接螺栓

Joint Reamer Bolt联齿铰配螺栓

rail joint bolt钢轨螺栓

joint bolt of runner blade轮叶连接螺栓

rim joint bolt轮缘螺栓

joint angle bolt插销螺栓

joint t bolt连接螺栓

universal joint bolt万向节螺栓

track bolt轨道螺栓；轨条螺栓；鱼尾螺栓，夹板螺栓；接头螺栓

butt joint bolt对接螺栓

dry joint with bolt插销式

英汉例句

• then the paper presented where the first danger point of joint bolt taken place under working stage, and checked fatigue stress life of the bolt.

  得出了螺栓工作状态下最危险点发生的位置，考核了螺栓的疲劳强度安全系数，分析结果表明，螺纹连接是一种弹塑性模型。

• to guarantee the reliability and security of the steel construction, the clamp load of the joint bolt should be under strict control, sometimes even the tension of the bolt should be measured on-line.

  为确保钢结构工程的可靠性和安全性，必须严格控制连接螺栓的预紧力，必要时还要在线监测螺栓工作应力。

• as the bolt tension increase, the tension of rail web, stress of joint bar and stress of joint bolt would increase accordingly, but the displacement of rail would become smaller.

  螺栓扭矩增大，接头区钢轨轨腰拉力、夹板应力、螺桿内应力都会增大，而钢轨位移会随着螺栓扭矩的增大而减小。

• addition of chamfering shape on seating surface of joint bolt at atf cooler pipe area.

  倒棱增加物的塑造在自动制冷管的范围内、头螺栓的座套表面。

• based on the 3d analysis result, shear models of ring joint bolt is built and shear parameters between rings needed in 2d analysis with beam-spring model can be obtained by this shear model.

  然后，在对三维有限元分析结果研究的基础上，建立了环缝处的纵向螺栓剪切模型，利用该模型可以计算得到错缝拼装衬砌二维梁-弹簧模型中环间剪切弹簧的刚度；

• in this paper, we programmed with ansys parametric design language(apdl), designed and optimized the main shaft fasten joint bolt considered nonlinear behaviors using fea software ansys.

  本文说明，利用先进的有限元应用软件ansys ，充分考虑到结构的接触和摩擦非线性行为，使用ansys的apdl脚本语言编制参数化程序，设计和优化主轴联轴螺栓。