片语

oil l drain plug放油塞

oil pan drain opening油盘排油口

oil l drain valve放油阀

Oil pan drain plug机油盘放油塞

oil l drain hose排油软管

Oil-drain plug放油塞

oil reservoir drain cock贮油槽放油开关

oil pan drain cover油盘排油口盖

英汉例句

• It meets the current demand for oils with fuel saving properties and with extended periods between drainage Super extend oil drain in accordance with the manufacturers instructions.

  它符合节省燃油的要求和根据制造商规定的延长换油周期需求。

• Heat the oil drain pan, add ginger.

  铁锅烧热放油、加姜片。

• The loading ability is moderate according to the potential indices evaluative criteria for longitudinal oil drain system and transverse direction oil drain system.

  按照纵向排油系统和横向排油系统的潜力指数评价标準，烃源巖的充载能力中等。

• Is it safe to increase oil drain intervals?

  增加放油间歇时间是否安全？

• The results of bench evaluation indicate that the most quality targets are in the range of national standard for oil drain except viscosity.

  试验结果表明，油样的大多数质量指标都在规定的换油周期内，只有粘度超过了国家换油标準。

• The lubricating oil depositing in different refrigerating equipment can not be drained out in time through conventional oil drain operation.

  传统的放油操作不能及时将沉积在各制冷设备中的润滑油排放出来。

• Acidic corrosion and rusting are controlled by formulation of the oil while the abrasive wear is controlled by air and oil filtration and oil drain intervals.

  酸性腐蚀与生锈是由机油成分所控制的，而磨料磨损是由空气、机油过渡与机油更换间隔时间所控制的。

• Undo the oil drain plug on the oil container and drain off the oil.

  拧下机油箱上的放油塞，并排放机油。

• Residual oil can be drained via valve at the rear of gear reducer and oil drain valve in thrust bearing oil sump.

  残油的排放可由减速机尾部的阀门和推力轴承油池的放油阀门来进行。

• Based on statistic analysis of automatic-controlled oil drain device in Shuanghe exploring well, the key causes have been found out of leading to the oil drain device fault.

  通过对双河油田开发井自控式泄油器故障的统计分析，找出了该种泄油器故障产生的主要原因。

• Powerful antioxidant activity, significantly extended oil drain intervals and reduce oil consumption.

  超强抗氧化性，极大延长油品换油周期，降低机油消耗。

• Out in the shaft loaded oil ring groove or by centrifugal force along the axis of the oil drain off the surface, the oil flows back to the assembly after the pool, and thus play a role in sealing.

  在轴上开出沟槽或装上油环，借离心力将沿轴表面外流的油甩掉，集结后流回油池，因而起到密封的作用。