英汉例句

• Adopt the automatic lubrication device and silicone oil lubrication suture device, the aperture depends very stable performance, can increase sewing efficiency and quality.

  采用自动润滑装置及硅油润滑缝线装置，故缝隙纫性能极为稳定，可提高缝效率和质量。

• Perfect oil lubrication system, extended the life of the machine.

  完善的注油润滑系统，延长了机器的使用寿命。

• A theoretical analysis of asperity contact is conducted for rolling point contact under oil lubrication condition.

  对油润滑条件下椭圆接触滚动表面的粗糙峰接触作了理论分析。

• The oil lubrication effect not only after oxidation, sell at a discount greatly, some acidity material will cause serious corrosion parts.

  机油氧化后，不仅润滑效果大打折扣，一些酸性物质还会对机件造成严重的腐蚀。

• Bearing seal type choice: the lubrication oil lubrication and can be divided into two greased.

  轴承密封型式的选择：轴承的润滑可分为油润滑和脂润滑。

• This article analyzed the status of low - press thick - oil lubrication of internal and external, put forward a new plan according to the practice.

  本文分析了国内外低压浓油润滑的现状，根据实际情况提出了一种新的方案。

• Labyrinth seal for grease lubrication and oil lubrication are valid.

  迷宫式密封用于脂润滑和油润滑都有效。

• A newly developed oil lubrication cold-drawing process to produce steel pipes is briefed in the article.

  简介了用于冷拔钢管生产的油润滑冷拔法的特点。

• Put forward by three oil lubrication device and cut off the board of the design, make the oil spill get as much as possible to use.

  提出润滑装置采用三层油桶加中间阻隔板的设计，使溢出的润滑油得到尽可能多的利用。

• The 24 XYZ type thin oil lubrication stations in Shajiao a Power station are used to lubricate and cool the friction parts on the motor bearing of the boiler forced and induced draft fans.

  沙角A电厂共有24台XYZ型稀油站，用于锅炉送、引风机的电动机轴承摩擦部位的润滑和冷却。

• Suitable also for many circulating, splash or ring oil lubrication systems.

  本产品亦适用于多种循环、飞溅或油环式之润滑系统。

• Dryer quantity is according to demand, driving the side machine is closed gear box. Dry bearing and spread drive gear adopt oil lubrication system.

  操作侧为箱形机架，传动侧为封闭齿箱，烘缸轴承及其传动齿轮均采用稀油润滑。

• The control requirement of humidity, pressure and cleanness of diluted oil lubrication system of high speed wire mill and the working principle of each element of the system are introduced briefly.

  简要介绍高速线材轧机稀油润滑中对温度、压力清洁度的控制要求及系统中各元件的工作原理。