英汉例句

• Demand is the original pulling force of economic growth.

  需求是经济增长的原始拉动力。

• The gap is influenced by water pressure gravity of equipment; magnetic pulling force and heat expand.

  间隙的大小受水压，设备自重，磁拉力和热膨胀等影响，其中以热膨胀的影响因素最大。

• A guide way of the pulling force pliers and the surface of the bottom seat are provided with the graduations for displaying the line elongation.

  拉力钳的导轨和底座表面上均有刻度，以显示线伸长率。

• Performance: acid, alkali, high temperature, pulling force and wearability.

  性能：耐酸、耐堿、耐高温、拉力和耐磨性强 。

• In the condition of no sufficiency of the deflection of two-end fulcrum and elasticity of bearing cable, the calculation of pulling force to any load is done.

  本文在充分考虑林业集运材多跨索道承载索两端支点的可挠性及承载索弹性的不完整性的情况下。研究了任意载荷时的拉力的计算。

• The maximum working pulling force of bolt-set connection under a bending moment is measured and analyzed.

  对受翻转力矩螺栓组联接的最大工作拉力进行测试与分析，提出符合实际受力状态的精确计算方法。

• The maximum working pulling force of bolt-set connection under a bending moment is measured and analyzed. An accurate calculation method is presented, which tallies with the actual situation.

  对受翻转力矩螺栓组联接的最大工作拉力进行测试与分析，提出符合实际受力状态的精确计算方法。

• The pressure safety devices can help to retain the draw bar pulling force in the event of a breakdown of the hydraulic system.

  安全阀可以防止因液压系统故障等原因而引起的油缸输出推（拉）力急骤下降，可确保加工安全。

• This system employs the pulling force sensors to detect traction force and USES capacitance running asynchronism motor with other parts to control traction force.

  系统采用拉式负荷传感器检测牵引力度，用电容运转式异步电机及其配套装置来控制牵引力度。

• This article has discussed that the hardware structure and the software development of computer control system of the pulling force test machine.

  本文讨论了拉力试验机计算机控制系统的硬件组成及其软件的开发。

• As the east end of the bridge is under-developed, the functions of the passage, radiation and pulling force of the continental bridge are not brought into full play.

  由于陆桥东端经济发展水平不高等因素，大陆桥的通衢、辐射、拉力作用发挥不够。

• Design and calculation method of the key parameter such as the diameter of roller and pulling force are given.

  介绍两辊式和三辊式机械弯曲除锈原理，给出关键参数如辊子直径、牵引力等的设计计算方法。

• When tensile force value dispersed degree of steel wire is low, broken pulling force of wire rope is high.

  当钢丝拉力值的离散度较小时，钢丝绳的整绳破断拉力值大。

• Flow into the cylinder can be directed to either end, producing either a pushing or pulling force at the piston rod end.

  可以控制油液流如液压缸的其中一端，在活塞桿上产生一个拉力或产生一个推力。

• To state the restoring force of a simple pendulum during oscillation is the resultant force of the gravity of the ball and the pulling force of the thread is wrong .

  常出现一些模糊认识，即认为单摆在振动中所受的回复力就是摆球所受重力与绳子拉力的合力，显然，这是错误的。

• It is the result of both the pulling force from positive factors in society environment and the thrust from negative factors in the organization.

  文章认为，雇员离职是社会环境积极因素形成的拉力和组织中的消极因素形成的推力，共同作用于雇员的结果。

• For laying indoors , in tunnel, cable trench, or direct in ground, able to bear external mechanicalforces, but unable to bear large pulling force .

  室内、隧道、电缆沟内，或埋地敷设等，能承受一定机械外力，但不能承受大的拉力。

• The combination of the spinning wire and constant pulling force cuts a path through the concrete and steel reinforcement.

  结合纺纱线和不断削减一条拉力钢筋混凝土和通过。

• Based on turning with inclined large cutting edge, a certain pulling force is exerted on chips in the flow chip plane to perform chip - pulling machining.

  本文以大刃倾角斜角车削为基础，在流屑平面内对切屑施加一定的拉力，进行拉屑切削。

• The axial frictional pulling force and the minimum thickness of mucus film were analyzed and calculated in detail when rectangular or trapezoidal cylindrical screw was being adopted in microcomputer.

  详细分析计算了微型机器人在采用矩形和梯形圆柱螺旋时的轴向摩擦牵引力和最小粘液膜厚度。