英语释义

1. a screw screwed through one part tightly upon or into another part to prevent relative movement

2. a screw for regulating a valve opening or a spring tension

片语

hex head set screw六角头止动螺钉

hollow-head set-screw空心头固定螺钉

headless set-screw无头定位螺钉

set t screw piston pin固定螺钉式活塞销

band wheel set screw带轮主头螺丝

set-screw wrench止动螺钉扳手

set t screw止付螺丝

chilly water set of screw螺桿式冷水机组

square-socket set-screw内方头紧定螺钉

英汉例句

• the stop collars are available in three types: knock-on type, spiral nail type and set screw type.

  有敲击式、螺旋钉式、内六方螺钉式三种结构形式供选择；

• this may require loosening set screw to raise or lower arm and lightly tightening it again to maintain arm position.

  这时可能要求松开固定螺丝升降唱臂然后轻轻紧固螺丝来暂时固定唱臂。

• by this way, a blade holder is formed which is attached on the horizontal shaft by a set screw ( not by nuts ).

  这样，刀片的持有人是形成现附上上醒目的轴由一套螺钉（而不是由坚果）。

• add a pneumatic consecrated themselves type air filter (hereinafter referred to as zkg) for the existing three set screw compressor use.

  增设一套气动自洁式空气过滤器（简称zkg）供现有三台螺桿压缩机使用。

• assemble flag on stem and tighten 1/2「 set screw to secure.」

  将指示器装配在阀桿上，紧固1/2“固定螺丝以确保安全。

• avoid stressing the two lines on which the arm is suspended. lightly secure set screw (accessible through hole on right edge of base) using supplied hex key.

  使用附带的内六角螺丝刀轻轻拧紧固定螺丝（从唱盘基座右边的透孔可以操作）。

• four, set screw can be pressed out, seat can be adjusted and replaced, valve can be used and avoid sealing which is out of using than all valve is abandoned.

  可将压紧套拧掉，调整或更换阀座，阀门仍可继续使用，避免了现行众多阀门密封失效后整台报废的弊端。

• generation 4 clousure technology—a reverse-angle set screw designed to thread easier, hold stronger, and reduce the implant even.

  第四代螺纹技术——螺塞反角螺纹设计，更易于安装，对棒抱紧力更强，进一步减少钉头体积。

• an adapter flange will be needed in the case of the direct input method with a key type, set screw type or taper collet type.

  键槽式、设置螺栓式或锥式直接输入的外箱应采用调配器法兰。