英汉例句

• the settling time of the circuit is particularly important when making high resistance measurements.

  在进行高电阻测量时，电路的建立时间特别重要。

• a low current measurement system may also require significant settling time be fore the expected accuracy can be obtained.

  对于小电流测量系统，也需要足够的稳定时间才能够获得预期的準确度。

• the parameters of pid controller are solved by z-n method. finally, settling time and positioning definition is compared under feedforward control and normal control, respectively.

  对前馈控制和无前馈控制的调节时间、定位精度进行了比较，验证了前馈逆补偿控制方法的有效性。

• switching speed, overshoot and settling time of components such as vcos can be measured under precisely the conditions in which they will be applied.

  开关速度快，超调量和解决的组件，例如vco的时间可以精确地测量了下，他们将应用的条件。

• thus, a settling time of 50 seconds would be required for the reading to settle to within 1% of final value.

  因此，为使读数稳定到与其最终值相差1%，就需要50秒的建立时间。

• aiming to decrease overshoot, undershoot and settling time of non-minimum phase system with time delay, this paper proposes an intelligent imc control system based on fuzzy inference.

  为同时抑制时滞及非最小相位系统的超、负调和加快系统响应，本文提出一种基于模糊推理的智能内模控制系统。

• the research results indicate that gradual reduction of settling time may reduce the startup time for aerobic granular systems under the same biological and chemical conditions.

  在活性污泥颗粒化的启动试验中，在生物化学条件相同的条件下，逐步缩短沉淀时间可以加快好氧污泥颗粒化系统的启动。

• we measured data curve fitting, the establishment of time and displacement curve of the corresponding relationship between the judge and the settling time final settlement.

  对实测数据进行曲线拟合，建立时间与位移量的变化曲线的对应关系，判断最终沉降量及稳定时间。

• the results illustrate that applying augmented lagrangian optimization methods have better convergence and the settling time is short.

  扩展拉格朗日优化方法具有较好的收敛性，且定位时间较短。

• an adaptive phase-locked loop (pll) with a fast settling time and its key blocks including phase-frequency detector (pfd) and charge pump are then proposed and analyzed.

  提出并分析了一种自适应的具有快速建立时间的锁相环结构及其关键模块（鑒相鑒频器和电荷泵）。

• on the theory of sliding mode controlling, this paper presents the method of dual pid regulation based on overshoot, by which both the small overshoot and the short settling time are realized.

  根据滑模控制的思路，给出了一种基于超调量的双pid调节方法，既能实现较小的超调量，又能实现较短的调节时间。

• it will result in the settling time longer or error response infinite norm larger when there are near cancellation of stable pole-zero near the jω-axis.

  名义系统接近于虚轴的稳定零点与补偿器的稳定极点近似相消导致反馈控制系统的调节时间延长或者误差响应的无穷范数变大。

• mirror lock-up can drastically increase sharpness for exposure times comparable to the settling time of the mirror (~1/30 to 2 seconds).

  镜片震动停止的时间需要1/30--2秒，反光镜锁定可以大大增加曝光的敏锐度（mirrorlock-upcan drasticallyincreasesharpnessforexposuretimescomparabletothesettling timeofthemirror (~1/30to2seconds).）

• the present paper has studied the influences of ph of wastewater by adding the amount of gcas, pass and settling time on the cod removal rate and photic degree with the optimum conditions obtained.

  采用实验室制备的淀粉丙烯酰胺接枝物（gcas）和聚硅酸硫酸铝（pass）混凝剂对制浆造纸废水进行处理，考察了ph值、药剂用量及沉降时间等对cod去除率和透光度的影响，得出了最佳实验条件。

• the effects of mass concentration, aeration rate, feeding mode, settling time on the biodegradation of butyl xanthate were investigated.

  在工艺优化阶段，考察了曝气量、进水方式、沉降时间等反应器参数对丁基黄药生物降解效果的影响。

• the aerobic granules could be cultivated successfully in the sbr by changing the operating conditions, and the shorter settling time was the primary affecting factor.

  在序批式反应器中，通过改变操作条件培养出颗粒活性污泥，较小的沉淀时间是产生颗粒污泥的主要因素。

• the current should be measured after a sufficient settling time to allow the switching transients to decay and the current to stabilize.

  应该等待足够的时间，使开关瞬态信号衰减，电流达到稳定，然后再进行测量。

• the influences of addition amount and concentration of chlorine dioxide as well as settling time on the effects of water treatment with chlorine dioxide are studied.

  探讨了用二氧化氯处理水时其加入量、浓度及沉降时间对处理效果的影响。

• in this case, the limitation on the loop bandwidth will impair the settling time of the pll and make it impossible to serve the requirement of the cmmb protocol.

  那么信道带宽对于锁相环环路带宽的限制将会使环路的锁定时间无法满足cmmb通信标準的指标要求。

• this system can approximately simulate the extrusion process and calculate the output of the extruder, brimming length along the axis of screw, materiel settling time etc.

  本系统能近似地模拟挤出过程，并预测挤出机的挤出产量、物料沿螺槽的充满长度、物料的停留时间等。

• after a relay is closed, it's important to allow sufficient settling time before taking a measurement.

  在继电器被闭合后，在进行测量之前要留有足够的稳定时间，这点非常重要。

• the settling time of the measurement is affected by the shunt capacitance, which is due to the connecting cable, test fixturing, and the dut.

  测量的建立时间受并联电容的影响，而并联电容则是由连接电缆、测试夹具和dut 产生的。