片语

shear-strain amplitude剪应变幅

maximum shear strain amplitude最大剪应变幅

strain-energy amplitude应变能振幅

Elastic Strain Amplitude弹性应变幅

Plastic Strain Amplitude塑性应变幅

strain n amplitude应变幅度

strain variation amplitude变形变化幅度

alternating strain amplitude更迭应变幅度

英汉例句

• The fatigue behavior of as-cast and as-extruded AZ91 magnesium alloys was investigated under total strain amplitude control mode.

  研究了铸态和挤压态az91镁合金的室温应变疲劳行为。

• The values of plastic strain energy density are affected by the plastic strain amplitude and change with the cycle numbers.

  合金的塑性应变能密度受应变幅的影响且具有循环相关性；

• In this model, a new kinematic hardening equation was used; the non-proportionality, the effect of temperature and memorization for the maximum plastic strain amplitude were also considered.

  该模型给出了一个新的背应力演化方程，引入了非比例度参量，并且还考虑了最大塑性应变幅值记忆效应和温度效应的影响。

• Based on above fitted relation and equivalent viscous damping theory, a nonlinear constitutive equation of damping alloy depending on strain amplitude and frequency is put forward.

  将所得变化规律与等效粘性阻尼理论相结合，给出了一种依赖于应变和频率的非线性阻尼本构关系式。

• The effects of cyclic strain amplitude history and mean strain on the cyclic deformation behavior of pure copper were investigated.

  揭示了紫铜在应变循环下的循环应变幅值历史、平均应变对循环特性的影响；

• The observed phenomenon that both 7000 series alloys tested soften cyclically at smaller plastic strain amplitude and harden at larger plastic strain amplitude is explained.

  阐述了观察到的两种7000系列合金在小塑性应变幅下循环软化，而在大塑性应变幅下循环硬化的现象。

• The effects of the dwell time, strain rate, strain amplitude and their histories on the cyclic deformation behavior are investigated.

  研究了在具有不同保持时间、不同应变率、不同应变幅值及其历史对材料的循环变形行为的影响。

• Peaking effects were found on the plot of internal friction vs strain amplitude or time when the resonant frequency of anomalous peak closed to the normal one.

  当反常共振峰频率与正常共振峰靠近时，在内耗-振幅或内耗-时间图上呈现峰值效应。

• The normalized form of shear modulus vs. strain amplitude will be shown by a single curve, and that of damping ratio vs. strain amplitude by a family of curves or a band zone with shrunk ends.

  经归一化后，前者在平面上表示为单一的一根曲线，后者则表现为一簇曲线或两端是尖灭、。