英汉例句

• the switching circuit including a first switch and a second switch provides a first ac signal.

  开关电路提供第一交流信号并包括第一开关和第二开关。

• in contrast to conventionally used quasi-steady model, the developed model represents the dynamic response of converter switching circuit to nominal changes in operating point.

  与传统準稳态模型不同，该模型反映了换流器开关电路在工作点受到小扰动时的动态特性。

• if the output voltage is less than the predetermined voltage level, the switching circuit portion transmits an enhanced control signal to the regulation circuit.

  如果输出电压小于预定的电压电平，则开关电路部分将增强的控制信号传输到调节电路。

• on the basis of analyzing circuit of sn388 cross-station, the paper introduced the solution of failure in input circuit, protected circuit and switching circuit of cross-station.

  文中在对sn388交叉站电路进行分析的基础上，介绍了交叉站输入线故障、保护电路故障和转换电路故障的解决方法。

• this paper provides a kind of new designing form used in the photoelectric switching circuit. it solves the problem happened at the photoelectric switching circuit with low voltage and wide range.

  提出了一种新的光电开关电路设计形式（差分形式的光电开关电路），解决了在低电压宽供电电源下，光电开关电路难以正常工作的问题。

• in this paper, concrete affection on the switching circuit impluse waveform by the capacitance load has been analysed and some improve measures h…

  本文分析了容性负载对开关电路脉沖波形的具体影响，并提出了一些改善措施。

• receiving the third signal and based on a reference voltage, the switching circuit controls the pulse wave width of the switching signal so as to adjust output current of the power converter.

  切换电路接收第三讯号并依据一参考电压，以控制切换讯号的脉波宽度，所以可调整功率转换器的输出电 流。

• the switching circuit determines whether to apply the power supply voltage to a chip in response to the control signal.

  开关电路响 应控制信号确定是否向芯片施加电源电压。

• the faults of hard switching circuit are presented, the resonant technique by using a square series resonant circuit is analyzed and some basic circuits of resonant switching are given.

  首先通过介绍硬开关电路的缺陷，引出谐振技术，分析了二次串联谐振电路，给出了基本谐振开关电路。

• principle, circuit design, hardware structure, software flow and features of dual computer switching circuit of ftk-3 hump automatic control system are introduced in this paper.

  本文介绍了ftk-3型驼峰自动控制系统双机切换电路的原理、电路设计、硬件结构、软件流程和特点。

• the controller circuitry coupled to the converter controls the switching circuit according to the feedback signal so as to control the power to the load.

  控制电路耦合至开关电路，用于根据反馈信号控制开关电路以控制提供至负载的电能。

• the switching circuit is offen used in the pulse digital system. as the switching circuit is acted on by capacitive load, the working speed of the switching circuit is limited.

  开关电路是脉沖数字系统中常用电路之一，由于负载电容的影响，限制了该电路的工作速度。

• in this paper, concrete affection on the switching circuit impluse waveform by the capacitance load has been analysed and some improve measures have been put forward.

  本文分析了容性负载对开关电路脉沖波形的具体影响，并提出了一些改善措施。

• the resonant tank coupled to the switching circuit receives the first ac signal and generating a second ac signal for powering a load.

  谐振回路耦合至开关电路，接收第一交流信号并产生第二交流信号以给负载供电。

• this paper puts forward a soft switching circuit of snubber type with a mutual inductance. the analysis result and parameter design method of the circuit are given .

  提出了一种采用互感元件构成的缓沖式软开关电路的拓扑，同时给出了电路的分析结果和参数设计方法。