片语

friction n angle摩擦角

dynamic friction angle动摩擦角

ultimate friction angle极限摩擦角

friction peak angle峰值摩擦角

friction pesidual angle残余摩擦角

Peak friction angle尖峰摩擦角

submarine internal friction angle水下内摩擦角

internal friction angle内摩擦角

英汉例句

• The influence of the pile shape and the friction angle of the interface on the limit bearing capacity is discussed by an example. It indicates that…

  通过算例讨论了桩型及桩土接触面上的摩擦角对散体材料桩及其复合地基极限承载力的影响。

• Finally, the effect of the diameter on the cohesion and internal friction angle of coal samples is investigated.

  最后讨论了直径对煤样黏聚力和内摩擦角的影响。

• Secondly, the FLAC 3D was used to simulate planar multiple shear bands and friction angle and cohesion force were dependent on plastic strain.

  之后采用FLAC3D对平面剪切带网络进行了数值模拟，其中摩擦角及内聚力为应变软化。

• The results of the undisturbed soil showed decrease in both cohesion and internal friction angle occurred by wetting, while little change in the strength parameters was observed for the remolded soil.

  结果显示未扰动土样的粘合力和内摩擦角在湿润化后都下降了，而所观察到的重塑土的弹度参数只有少许变化。

• The influence of the pile type and the friction angle of the contact surface on the limit bearing capacity of the piles and the composite foundation is discussed with an example.

  通过算例，讨论了桩型及桩土接触面上的摩擦角对散体材料桩及其复合地基极限承载力的影响。

• The stiffness coefficients, cohesion, friction angle are the important parameters in reflecting the mechanical characteristics of the joints.

  巖体节理面的刚度系数、黏结力和内摩擦角是反映节理面力学特性的重要参数。

• Extreme type I isn′t equal to be probability distribution of cohesion and internal friction angle of clinosol and residual cohesive soil surrounding rock.

  极值I型分布不适宜作为坡残积黏土质围巖黏聚力、内摩擦角的概率分布；

• The cohesion and internal friction angle increase with the increase of compaction under the same water content.

  在同一含水率下，黏聚力和内摩擦角随试样压实度的增加而增大；

• The anti-slide reliability is reduced when the positive correlation among the friction coefficient between fill and ground and the friction angle of fill is applied.

  忽略填土与基底的摩擦系数和填土内摩擦角之间的互相关性，则加筋土挡墻的抗滑验算偏于危险；

• To avoid slip of CFRP bars, the friction angle between soft metal pipe and CFRP bars should be larger than the sum of barrel's conical angle and friction angle between wedge and barrel.

  为保证碳筋不出现滑移，软金属管和碳筋间的摩阻角应大于锚环锥角和夹片与锚环之间的摩阻角之和；

• The analysis of the friction angle effected by the dimension tolerances of the needles and shaft are given in this paper.

  本文在沖压成型外圈的锁紧斜面尺寸难以修改的前提下，分析了其配用的滚针或轴（内圈）的几何尺寸变化对摩擦角的影响。