片语

Friction drag coefficient of motion运动阻力系数

friction n coefficient of masonry砌体摩擦系数

tube friction resistance coefficient管道摩阻系数

friction effect coefficient摩擦影响系数

friction resistance coefficient摩阻系数

friction axis coefficient摩擦系数

friction n coefficient摩擦系数

friction lo coefficient摩擦损失系数

friction loss coefficient摩擦损失系数

英汉例句

• it is fairly easy to measure a friction coefficient by putting an object on an incline and by changing the angle of the incline, increasing it this is the angle alpha.

  测量摩擦系数有一种简单方法,把物体放置在斜面上,然后不断增加斜面的倾斜度,这是角α

• and let the friction coefficient mu 2 be one-fifth, 0.2.

  假设摩擦系数μ,等于0。

• with graphite particle content increasing from 5% to 20%, wear weight-loss and friction coefficient of the composites are obviously declined, greatly improving wear resistance of the composites.

  随着石墨颗粒含量从5%增加到20%，镁合金基复合材料的耐磨性得到明显的改善，磨损质量损失与摩擦系数都降低到较低水平。

• in the default model the friction coefficient is defined as afunction of the equivalent slip rate and contact pressure.

  在默认模型里，定义摩擦系数为等效滑移率和接触压力的函数。

• i told you that the friction coefficient is independent of the mass of the object.

  我讲过,摩擦系数,与物体质量无关。

• the effect of surface phase constitution, surface roughness, sliding speed, press force and anti- rust oil on friction coefficient of galvannealed if sheet steel has been tested and researched.

  采用平板滑动实验研究了表面相组成、表面粗糙度、拉速、压力及涂油品种等因素对汽车用合金化热镀锌if钢表面摩擦系数的影响。

• it is very nonintuitive that this friction coefficient is completely independent of the mass.

  我们惊讶地发现,公式中摩擦系数,与质量完全无关。

• there is another way that one can measure the friction coefficient which is way more complicated and really, that「s not the reason why i want you to see it.

  测量摩擦,其实还有一种方法,一种更复杂的方法,复杂的方法,不是目的。

• that should allow you to calculate the static friction coefficient and you」ll get a chance to do that in your third assignment.

  这样一来,请计算静摩擦系数,它将作为你们第三次作业的,一部分。

• whoosh that your friction coefficient goes almost to zero.

  ,摩擦系数计划变为零。

• however, in some application conditions, low hardness, big friction coefficient and poor wear resistance confine its extensive application in engineering.

  然而，在某些应用条件下，钛合金的硬度低，摩擦系数大，耐磨性差。

• there, the kinetic friction coefficient remains constant independent of the speed.

  这里，动力摩擦系数,独立于速度之外。

• if indeed the friction coefficient is independent of surface area, then when i tilt them they should start to slide roughly at the same angle.

  若摩擦系数真的,与接触面积没有关系，那么两者下滑时的角度,应该基本相当。

• so it「s only a poor-man」s version of what i discuss there, but in any case, the friction coefficient with the floor is substantially larger than the friction coefficient here.

  只是我这个糟老头子,的一些观点，无论在哪个例子里，和地板的摩擦系数,实际上都会,大于这里的摩擦系数。

• the results show the friction coefficient of wet friction material is small and steady, ranging of 0.07-0 13.

  结果表明：该湿式摩擦材料的摩擦系数小而稳定，在0.07-0.13间波支国。

• so you should be able to calculate what the friction coefficient is using the equation tangent alpha equals mu s.

  你们则需要学会,计算摩擦系数,使用μ静=tanα这个公式。

• the friction coefficient of the coatings decreased with increasing load.

  涂层的摩擦系数随着载荷的增大而降低；