片语

Cam minimum setting value最小送线指令

Winder maximum setting value最大卷圈轴指令值

speed setting value转速设定值

truck model setting value载重车型号设定值

double-setting-value双整定值

Relay protection setting value继电保护定值

Winder minimum setting value最小卷圈轴指令值

SETTING OR VALUE设置或值

maximum setting value凸轮轴最大设定范围

英汉例句

• The control device can input a setting value, and compares the flow signals with the setting value to generate a control signal, so a warning device is controlled according to the control signal.

  一控制装置可输入一设定值，并将前述流量信号与该设定值比较，而产生出一控制信号，借以根据该控制信号控制警示装置。

• The control system of the compressor adopts frequency conversion to control, its frequency setting value is decided by the non-linear link.

  压缩机控制系统采用变频控制，其频率给定值由非线性环节来决定。

• It puts forward the setting principle and method of load limiting resistor of backup distance protection and gives the propositional setting value of load limiting resistor.

  对四边形和方向圆特性阻抗继电器躲线路最大潮流的能力进行了详细分析，提出了距离保护负荷限制电阻的整定原则和整定方法，并给出了整定建议值。

• Then the computer algorithms are proposed in terms of the principle of dual protection setting value calculation and a setting value calculation scheme design of distribution network is made.

  研究了二段式保护的整定计算原则，结合实际提出了各种保护整定的计算机算法，并在此基础上开发了配电网络的保护整定计算方案设计。

• The pointer offset value and sensor gain setting value selected by this operation are not initialized by SETUP RESET or DEFAULT SET operation.

  这里操作选定的指针偏差值和感应增益设定值不用「归零设定」或「错误重调」来清除。

• According to the power factor of compensation point, the controller chooses different control strategies to maintain the power factor between the setting value and 1.

  控制器根据补偿点的功率因数大小，实时选择控制策略，使补偿点的功率因数值维持在设定值和1之间。

• In site operation, stator grounding protection often gives false signal, therefore some units raise the setting value greatly for the dependability of protection.

  现场运行中定子接地保护误发信号时有发生，一些单位为使保护运行可靠，从而大幅度提高定值。

• Secondly, a theory that can automatically adjust the action frequency of UFLS device is applied. UFLS device can adjust setting value by maximal and minimum final value of local frequency.

  其次，提出了一种自动调整低频减载装置动作频率值的理论，低频减载装置将根据局部频率最大终值和最小终值来改变其设定值。

• Take OMRON CPM1A as an example, the changing setting value methods in which we use analog input potentiometer, dial switch and push-switch are introduced.

  以OMRONCPM1A为例，介绍了用模拟输入电位器、拨码开关和按钮等方法改变定时器的设定值。

• Temperature control card protects setting value and avoids change by mistake.

  温度控制卡设计，保护设定的温度值，防止误改。

• We should always check the high voltage DC power supply within the current relay, time relay setting value is correct, control is sensitive.

  应经常检查高压直流电源内电流继电器，时间继电器的整定值是否正确，控制是否灵敏。

• In addition, the rotation feedback control is added to keep the practical rotation speed at setting value when FPC stands by.

  此外，还附加了转速反馈控制，使FPC转速在其待机时总是能保持在稳态给定转速。

• In order to achieve the best characteristics of the setting value tracking and the disturbance rejection, a PID controller optimization design method is put forward.

  为使PID控制器同时具有给定值跟蹤和抑制干扰两个方面的最佳特性，提出了PID控制器优化设计方法。