片语

Direct shear box test直接剪切盒测试

reversing shear box test往复直剪试验

shear stability test剪节稳定性试验

undrained shear box test不排水剪切盒试验

Shear Punch Test剪切沖孔试验

shear relaxation test剪切松弛试验

shear r test剪切试验

shear strength testSoil shear strength tests are used to determine the load on soil. Some of these tests are:

shear fatigue test剪切疲劳试验

英汉例句

• a new variety of cement-stabilized soil with additive was studied by consolidated undrained triaxial test(cu test), direct shear test and compression test.

  通过三轴试验、直剪试验和压缩试验，对一种掺有添加剂的新型水泥固化土进行了研究。

• specimens of composite wall panels in three groups are analyzed using finite element method and analyzing results are compared with the pseudo-static shear test results.

  对三组复合墻板试件进行了平面有限元分析并与拟静力试验结果进行了比较，分析了骨架曲线、墻板裂缝分布及发展、钢筋应力分布等。

• the resistance to shear by the direct shear test and the triaxial compression test in soil test is compared and analyzed. the different test method is adopted about the different work.

  对土工试验中直接剪切试验与三轴压缩试验所得的抗剪强度进行了比较与分析，从而对工程不同要求提出不同的试验方法。

• based on a large number of dynamic shear tests, several mechanical models of dynamic shear test of bulk materials have been established in this paper.

  本文在大量动态直剪试验的基础上，建立了散体在振动场作用下剪切试验的几个力学模型。

• finally use the dynamic three axle shear test to research impulsive load function under red clay mechanics and distortion characteristic.

  最后通过动力三轴试验仪研究沖击荷载作用下红粘土的力学和变形特性。

• this paper describes the correlation between the characteristic values of the micro shear test and those of the conventional tensile, fracture mechanical tests.

  本文介绍了微型剪切试验与拉伸试验、断裂力学试验等参数之间的对应关系。

• the dynamic triaxial shear test on the dynamic properties of the xiaolangdi in situ siltized intercalations within core samples is performed.

  对黄河小浪底工程左岸山体含泥化夹层的巖芯试样进行了动三轴试验研究。

• adhesive layer materials for different conditions may be recommended by using of direct shear test and pullout test with sbr modified emulsion asphalt, sbs modified asphalt and japan epoxy binder.

  采用sbr改性乳化沥青、sbs改性沥青和日本环氧粘结剂三种层间粘结剂，利用直剪试验和拉拔试验进行层间抗剪性能分析，可以推荐出适合不同条件的粘结层材料。

• vane module for interpretation of vane shear test and making vane sounding logs (only for vst with full electronic registration).

  解释十字板剪切试验，记录十字板探空（仅适用于完整的vst电子注册）。

• in order to study the correlation between shear wave velocity of soils and their triaxial shear test mechanics index, a new transducer is developed on the basis of torsion vibration principle.

  为了研究土的剪切波速与其三轴剪切试验力学指标之间的关系，依据扭剪振动原理，开发出一种测试三轴压力室内土样剪切波速的传感器。

• a direct box shear test on granular material is successfully simulated by means of distinct element method.

  用离散单元法模拟了粒状体的直剪试验。

• the problems existing in large shear clamp for shear test of pins are analyzed in detail in this paper, and practical improvement method is given.

  对现有的剪断销剪切试验用重型单剪装置存在的问题进行了系统分析，提出了对该重型单剪装置结构优化的具体方案和实施办法。

• a single shear test about cfrp-steel member was performed to investigate the shearing bond performance between cfrp sheet and steel member.

  采用碳纤维布-钢构件搭接接头的单剪试验方法，深入研究了碳纤维布-钢构件的抗剪粘接性能。

• the experimental studies on frictional sliding of four kinds of rocks were made by the double shear test method.

  用双剪法对四种巖石的摩擦滑动特征进行了实验研究。

• this paper introduces the results of unconfined compression test, direct shear test and unconsolidated undrained triaxial test for saturated clay at a site in shanghai.

  本文介绍了上海菜工程地基饱和粘土的无侧限试验、直剪试验及三轴不固结不排水试验的结果。

• the bond behavior between frp plate and concrete is studied by experiment on a single shear test setup.

  采用碳纤维布-钢构件搭接接头的单剪试验方法，深入研究了碳纤维布-钢构件的抗剪粘接性能。

• comprehensively analyse the date of survey and test in soft ground. a method of assessing the stress history of soft clay by vane shear test (vst) is induced.

  通过对软土地基勘察试验成果的综合分析，归纳出用十字板试验评价软弱粘性土层应力史的方法。

• second, based on a large number of shear test data abroad, using the neural network model to study the components of reinforced concrete beam shear properties.

  其次，在收集国外大量抗剪试验数据的基础上，用神经网络模型来研究钢筋混凝土梁的抗剪性能。

• large scale triaxial shear test on spherical particle coarse aggregate is carried out.

  采用大型三轴仪对球形颗粒散粒体进行了应变式三轴试验。

• the characteristic values of micro shear test and tensile test of aluminium alloy were determined and the quantitative expression of these characteristic values were studied.

  通过测定铝合金微型剪切试验和拉伸试验的性能参数，研究得出了这些性能参数之间的数学关系式。