英语释义

1. capacity of a material or a union to resist shear

片语

shear transfer strength剪力传递强度

twin shear stress strength双剪应力强度

shear yield strength剪切屈服极限

tensile shear adhesive strength拉伸剪切粘接强度

shear bond strength抗剪切强度

compressive shear adhesive strength压剪粘接强度

apparent shear-strength表现抗剪强度

twin shear unified strength双剪统一强度

shear r strength剪切强度

英汉例句

• the formula of reduced shear strength coefficient of rc beams with inclined cracks is put forward to according to the test data.

  根据试验数据提出了存在斜裂缝钢筋混凝土梁的抗剪强度折减系数的计算公式。

• the results indicate that waterproof binding course influences shear strength and performance of waterproof significantly, and mix design gradation has no effect on shear strength.

  试验结果表明：防水粘结层类型对层间抗剪强度影响显着，而试验采用的级配对层间抗剪强度影响很小。

• in accordance with the special characteristics of this type of ship, a proper load predication method is adopted for hull longitudian strength, shear strength and transverse strength.

  本文针对船型的特殊性，采用了适宜的载荷预报方法，妥善地解决了该船体的总纵强度、剪切强度及横向强度。

• soaking leads to a significant increase in compression deformation and a significant reduction in shear strength and cohesion.

  压实粘土浸水饱和后，压缩变形显着增加，抗剪强度和粘聚力则显着降低。

• shear strength of undisturbed soils has positive correlation with root content, and relevant regression models about undisturbed soil were established.

  原状土的抗剪强度与含根量呈正相关，并以此建立关于原状土的抗剪强度回归模型。

• result: isogradient ha coated implants had significantly greater average interface shear strength than the uncoated implants at each of the time interval.

  结果：在术后任一时间段涂层植入体界面抗剪强度均显着高于非涂层者。

• shear strength and shear strain are the basic properties in mechanics of concrete. they also serve as important data for finite element and failure criterion research on concrete.

  抗剪强度和剪切变形是砼的基本力学性能，又是强度理论研究和有限元分析的重要数据。

• the results indicate that cement mixing ratio , water content and comparative effort have important influence on shear strength , compressibility and microstructure of the compacted cement -loess .

  试验研究表明，水泥掺入比、初始含水量和夯实功对夯实水泥黄土的抗剪强度、压缩性和微观结构有着重要的影响。

• as samples, the distributions of ice sheet design thickness, compressive strength, flexural strength, shear strength and elastic modulus for ice periods of 25, 50 and 100 years are presented.

  作为实例，给出渤海25、50、100年重现期的平整冰层设计厚度分布、压缩强度分布、弯曲强度分布、剪切强度分布和弹性模量分布。

• the tests indicated that the ultimate shear strength of it was a little larger than normal-weight concrete beam's, and larger than lightweight concrete beam.

  结果表明，高强次轻混凝土梁比轻集料混凝土梁的抗剪承载力有较大的提高，且比普通混凝土梁的抗剪强度大；

• three typical manifestations of wafer bonding strength were introduced as tensile strength, shear strength and adhesive strength.

  介绍了三种典型的圆片键合强度表现形式：抗拉强度、剪切强度和粘接强度。

• i have a chance to use the equipment of triaxial test which import from england and to carry on research shear strength of asphalt mixture.

  本文有机会借助英国进口的三轴剪切试验设备，对沥青混合料的抗剪性能采用三轴剪切试验进行深入研究。

• the shear strength of dry sand has been studied, the result shows the interlocking strength existing interdry sands compacted.

  对干砂的抗剪强度进行了研究，认为型砂存在咬合强度。

• the study results indicate that there is a soil liner shell outside the mortar liner shell, and the shear strength of the soil liner is obviously higher than the undisturbed soil.

  研究结果表明，砂浆衬砌外侧存在一个抗剪强度明显高于原状土体的土质外衬。

• the drawing test results show that the shear strength of the interface is not proportional to the normal stress because of its dilatancy behavior due to shear application.

  土工布拉拔试验结果表明，由于土与土工织物接触面的剪胀造成该类接触面的抗剪强度与法向应力不再是线性关系；

• result:isogradient ha-coated implants had a greater average interface shear strength than the uncoated ones at each time span.

  结果：术后每一时间段涂层植入体界面抗剪强度均显着高于非涂层者。

• bonding temperature, bonding time and interlayer thickness have an obvious effect on the shear strength of the joints.

  连接温度、连接时间和中间层厚度对接头抗剪强度具有较明显的影响。

• in the range of incident velocities near to the perforation limit velocity(v50) , this mechanism depends on thickness and interlaminar shear strength of composite plate.

  在接近穿孔极限速度的入射速度（v50）范围内，这一机制依赖于复合材料板的厚度和中间层剪切强度。

• at last, by use of a practical project the author compared and analyzed the two sets of shear strength parameters obtained by two different stress paths.

  最后，本文利用某一基坑工程实例的实测土压力对两种路径下得出的抗剪强度指标进一步进行计算和分析对比。

• l9(34) orthogonal experiment was adopted, the effects of concentration of initiator, reaction time, volume ratio of monomers and amount of pva on shear strength of adhesive were investigated.

  采用l9（34）正交实验，考察了引发剂的浓度、反应时间、单体的体积比和pva用量对木材胶黏剂的剪切强度的影响。

• influences of the metallizing technologic conditions, ni plating and subsequent annealing on the joint shear strength were investigated.

  考察了金属化工艺、镀镍及镀后热处理对接头剪切强度和钎焊效果的影响。

• the shear strength and failure mode of the bond were researched during aging process.

  分析了铜丝球键合点老化过程中的剪切强度及失效模式。

• this paper deals with the calculation of the shear strength of reinforced lightweight concrete beams.

  本文就钢筋轻骨料混凝土梁的抗剪强度计算问题进行了论述。

• a simple formula for calculating pure shear strength of concrete is derived on the basis of the verified mathematical model of concrete failure surface, the elliptic paraboloid.

  本文根据已论证过的混凝土破坏面，即椭圆抛物面的数学模型，报导出一个用以计算混凝土纯剪强度的简单公式。

• based on the results of experiment and finite element analysis, the shear strength and the effect of reinforcement of the perforated brick walls are also discussed.

  本文还根据试验结果和有限元法分析，探讨了空心砖墻的抗剪强度和横向、纵向配筋效应。

• shear strength value of rock mass of slope is one of the important geological factors affecting stability of slope.

  边坡巖体抗剪强度参数是影响边坡稳定性的主要地质因素之一。

• the parameters of shear strength of slide zone soil are indispensable factors for stability evaluation and countermeasure design to landslides.

  滑带土抗剪强度参数的正确选取，是滑坡稳定性评价和抗滑工程设计中的关键问题。