片语

static bearing strength静承载强度

Static Bending strength静曲强度

static tensile strength静拉伸强度

static torsional strength静扭强度

static c strength静力强度

static compress strength静态抗压强度

static notch strength静切口强度

static gelling strength静胶凝强度

Static load strength analysis静载强度分析

英汉例句

• in the static strength analysis of helicopter blade, the traditional analysis method may lead to the uncertainty of the strength conclusion due to the inaccuracy of load calculation.

  在直升机桨叶的静强度分析中，传统的分析方法可能会由于载荷计算的不準确，给强度结论带来不确定性。

• in this paper, the static strength and the fatigue life of spring for seal flake in radial face on rotary engine is analyzed.

  转子发动机的径向密封片弹簧使密封片始终压紧缸体，从而使密封片起到密封作用。

• also, the calculation formula of the contact stress, the fatigue strength and the static strength for the small thrust bearing which are attached at the end face of roller are derived.

  同时又对滚子端面的小型推力球轴承推导出接触应力、疲劳强度和静载强度的计算公式。

• the static strength and stiffness values are determined by static analysis.

  通过静态分析获得结构的静强度和静刚度值；

• in order to ensure the safety of large oil storage tank, further research to the static strength and seismic response of tank are carried on.

  为确保大型油罐的安全，需要对油罐的静强度及地震响应进行进一步的研究。

• these results have been provided the essential data for programme fatigue testing and optimal design spectrum and static strength proof.

  为室内程序疲劳试验谱、有限寿命设计谱和静强度校核提供了可靠的依据。

• static strength analysis of compacting board under different working conditions were carried out.

  同时，对压缩板进行了不同工况载荷下的静态强度分析。

• with the results from the test, the empirical equations for calculating the static strength of the short cylinder and classifying long and short cylinder were derived.

  在试验的基础上，导出了计算短圆筒静强度的经验公式，及区别内压长、短圆筒的临界长径比计算公式。

• as for a propeller of a tugboat, it is necessary to calculate the fatigue strength in the self running state as well as the static strength in the bollard state.

  对拖船螺旋桨来说，除了应计算系桩状态的静态强度外，还应计算自由航行状态的疲劳强度。

• by means of calculating structure strength of the frame and doing static test of the frame quality of strength and rigidity of the frame are discussed in research of static strength loads.

  静强度载荷研究：通过机体结构强度计算及全机静力试验，论及静载荷下全机的强度与刚度品质；

• the device was improved according to the analysis result and static strength of improved compacting board was calculated. comparatively satisfactory improving project was achieved.

  利用分析的结果，对该装置进行了改进，并对改进后的压缩板进行了静态强度实验，得到了比较满意的改进方案。

• based on the uncertain non - probabilistic convex models, the non - probabilistic reliability design of shaft on static strength is proposed.

  基于不确定非概率凸模型，提出了轴静强度的非概率可靠性设计方法。

• the aim of induction quenching has been enlarged from only improving local wear resistance to improving whole static strength and fatigue strength of parts.

  感应淬火的目的已从仅仅提高零件的局部耐磨性扩大到提高零件的整体静强度和疲劳强度。

• the relationship between dynamic and static strength of soil is worth discussing.

  土的动强度与静强度之关系，国内外学者的研究成果不尽一致。

• a fatigue failure criterion is presented for unidirectional laminate under complex in plane fatigue loads based on the residual strength degradation model and tsai hill static strength criterion.

  基于唯象的剩余强度衰减模型与蔡-希尔静强度判据，建立单向层合板在任意复杂面内应力作用下的疲劳失效準则。

• experiments show that self-piercing riveting (spr) is better than spot welding with regard to static strength and fatigue strength for aluminum alloys joining, spr has a prominent application.

  试验证明，自沖铆接工艺在连接铝合金时，无论是抗静拉力和抗疲劳性都要好于点焊工艺，因此，自沖铆接机在车身轻量化制造中有很好的应用前景。

• the failure patterns of rock was formerly only studied on the bases of static loading and the static strength theory was adopted.

  以往研究巖石的破坏类型只停留在静载作用下，而其强度理论也多采用静态强度理论。

• a nonlinear and continuous strength degradation model is presented from the view point that fatigue damage process is the process during which material static strength degrades constantly.

  从疲劳过程本质上是材料静强度不断退化的过程的观点出发，建立了一个非线性的、连续的强度退化模型。

• the test result showed that the ratio of dynamic strength and static strength is 1. 25~1' 30, by which the value of low temperature tensile strength of material could be evaluated.

  实验结果表明，动态强度与静态强度的比值为1．25～1．30，利用此关系可以估算材料的低温抗拉强度值。

• described are the lightening design, energy absorption car-body design, finite element analysis, static strength test and modal analysis calculation.

  介绍了北京八通线地铁车体钢结构的轻量化设计、吸能车体设计、有限元分析、静强度试验和模态分析计算。

• the static strength has been regarded as the main design standard in port crane design for many years.

  多年以来，港口起重机设计大都将静强度作为主要设计準则。

• simultaneously about as 2/3 static strength as dynamic strength at same failure strain under equipressure consolidation condition of mucky soil in xiamen is gotten.

  同时得出厦门淤泥土在等压固结条件下相同破坏应变的动强度约为静强度的2/3。

• in paper, the structural static strength and dynamic characteristic of pole? tower of aerial power? delivery line are analyzed and discussed with the finite element analysis.

  主要利用有限元方法对架空送电线路桿塔进行结构强度和结构动力学特性分析。

• design method based on static strength analysis is safe enough and applicable.

  按静强度进行扭桿设计是安全的和合适的。

• using i-deas software, finite element analysis of static strength of low-sided weathering steel gondola car body is carried out.

  利用i-deas软件，对低边耐候钢敞车车体钢结构进行有限元静强度分析。