片语

bearing axial load轴承轴向载荷

bearing thrust load轴承推力载荷

joint bearing of load联合承载

bearing impact load耐沖击负荷

bearing-load rating轴承额定载荷

bearing g load轴承荷载

bearing radial load轴承径向载荷

bearing-load joints承力接头

英汉例句

• based on single-crank crankshaft, beam element whole crankshaft and solid element whole crankshaft model, the crankshaft deformation and main bearing load of n485 diesel engine are calculated.

  基于单拐曲轴、梁单元整体曲轴和体单元整体曲轴模型，分别计算了n485柴油机的曲轴变形和主轴承负荷；

• pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.

  输送皂角泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。

• based on the equivalent theory of statics this paper presents an accurate numerical method and accurate numerical formulas for calculating the bearing load distributed by cosine curve law are derived.

  本文根据静力学完全等效原理提出一种精确数值解法，并对余弦分布的轴承负荷转为节点力的解法作了具体的数学推导，得出了精确数值计算公式。

• it is known that in plane finite element calculation the bearing load must be transformed into force of nodal.

  在平面有限元计算中，必须把轴承负荷转为节点力。

• results indicated that: the bearing load capability of vierendeel truss is the worst. we shouldn't adopt this structure.

  结果表明，空腹桁架的受力性能最差，除非桁架跨度不大，建筑层数较小且抗震设防要求低，否则不宜采用；

• multi-support rotor-bearing system is one of crucial parts of large-scale rotary machine. the change of bearing load on rotor -bearing system would bring on great vibration and disastrous accidents.

  多支承转子-轴承系统是大型旋转机械的核心部件，其轴承负荷发生变化将引起转子系统的剧烈振动，导致重大事故的发生。

• planar bearing load cell designed particularly is used to alarm for travelling crane overload.

  特殊设计的平面承载式传感器，专用于天车过载报警。

• on the base of the traditional transfer matrix method, an improved method that can calculate the sensitivity matrix of bearing load to its elevation is presented.

  文章发展了传统的轴承载荷计算方法，使之可以求解轴承载荷对标高变化的灵敏度矩阵。

• base on the analysis of bearing load features, mechanism of pile foundation settlement and merit, demerit, applicability of calculation method were discussed;

  论文在对桩基承载特性进行分析的基础上，对桩基沉降的机理和现有计算方法中的优缺点和适用性进行了探讨；

• a new method is proposed to determine the excited torque and bearing load of the injection pump camshaft by means of measuring the longitudinal strain in the bottom part of the plunger.

  本文提出测量柱塞根部纵向应变以确定喷油泵凸轮轴激振扭矩及其轴承载荷的方法。

• these results demonstrate that the effect of improving the bearing load of structure is very good by strengthening the member of eccentricity compression under pre-stress.

  偏心受力构件的有限元计算结果表明：预应力法加固偏心受力构件，其对结构承载力的提高效果显着；

• the expression formula of desired overload coefficient is derived from analysis of the relationship between the bearing load of chain and the torque of motor.

  分析链条所承受力与电动机转矩的关系，推导出理想过载系数的表达式；分析摩擦限矩器的打滑磨损，给出摩擦限矩器设计过载系数的经验式。

• it studies also the feasibility of this way for on-line monitoring bearing load of turbine generators.

  研究测轴承支承力法对大型汽轮发电机组轴承负荷在线监测的可行性。

• the fault can be diagnosed and accident can be avoided on large-scale rotary machine by the way of motoring bearing load on rotor -bearing system.

  对多支承转子-轴承系统轴承负荷进行监测，可为机组安全运行和故障诊断提供指导，避免恶性事故的发生。

• for this account, the author provides a simplified method for estimating the bearing load of a single row diesel engine.

  为此，本文作者在研究了有关文献后，提出了单列式柴油机轴承负荷快速估算法。

• checking calculation of horizontal bearing load upon column by ordinary method is relatively complicated and not perfect enough on theory at present.

  按常规方法验算桩的水平承载力比较繁琐，目前在理论上的研究还不够完善。

• plate girders may be subjected to web crippling for concentrated bearing load in cold-formed steel structures without ending stiffeners or bearing stiffeners.

  引用国际上最新的试验研究，本文对冷弯薄壁非卷边槽钢承受集中荷载时腹板压屈进行了研究。