片语

belt slope tension翻译

belt tension idler pulley紧带惰轮

Fan belt tension风扇皮带张力

used belt tension旧皮带的张紧度

belt tension chart传动带张力表

belt tension starter皮带胀紧器

vee belt tension三角皮带张紧力

BELT TENSION METER皮带张力计

automatic belt conveyor tension皮带张力

英汉例句

• based on the analysis of the belt tension of engine, a measure of belt tension by measuring the camber of the engine's belt bent is found . this measure can be used in the assembly of the engine.

  通过对发动机皮带张紧力的分析，得出通过测量发动机皮带受力产生的挠度来测量发动机皮带张紧力的方法，并应用在发动机装配过程中。

• if this is not the case, the bearing must be subjected to an additional radial load, e. g. by increasing belt tension or idling torque, or by other means.

  否则必须给轴承施加径向载荷，例如，通过提高皮带张力或空转扭矩，或采用其他手段。

• the team conducted the gage r&r study and found the performance of the belt tension measuring equipment to be acceptable.

  小组进行量表r&r研究，发现皮带张力测量设备的性能是可接受的。

• according to the belt tension analysis of the large near-horizontal and upstroke conveyor during braking and starting, this paper gives the effects of brake location on the take-up tension.

  通过近水平和上运大型带式输送机制动工况和起动工况的张力分析，明确了制动装置位置对输送带张紧力的影响，进而提出大型输送机制动与张紧装置的优化布置方法。

• usually the same belt drives the alternator, and belt tension is adjusted by swinging the alternator on its mounting.

  这根皮带一般也驱动交流发电机工作，皮带的张紧度通过在支座上摆动发电机的位置来进行调整。

• this paper introduces the design of a belt tension measuring tool and its application research.

  介绍了一种皮带张紧力检具的设计及应用研究。

• with the increasing of the length of belt conveyors and the using of burning-proof belts. the existing take-up cannot meet the needs of belt tension for the stretching amounts of the belt increase.

  随着煤矿带式输送机长度的增加和阻燃整芯输送带的伸长量增大，现有的张紧装置难以适应这种输送带张紧的要求。

• however, because unsuitability and fluctuation of the steel belt tension as well as the shape irregulation of the steel belt, there will exist some influence on precision.

  然而，由于钢带张力不适当或张力波动较大以及形状不均等各种原因，会对钢带卷取精度造成一定的影响。

• the proportional direction valve and the proportional relief valve were adopted to timely control the belt tension and its working principles were introduce.

  分别采用比例方向流量阀和比例溢流阀来实时控制输送带张力，并分别介绍了其工作原理。

• the analytical results show that the influence of the variation of belt tension is most obvious, and that of the slotting angle and run-up angle are secondary on the curvature radius.

  张力的变化对曲率半径的影响最大，成槽角及抬高角的变化对曲率半径的影响也较大。

• the belt-tensioning and deviation-regulating device of a belt conveyer simple structure, strong practicality, and obvious effects of solving belt tension and regulating deviation.

  本装置结构简单，实用性强，解决皮带张力和调偏效果明显。

• the belt tension auto-control has been the trend of the belt take-up technology.

  皮带的张力自动控制已经成为皮带拉紧技术发展的方向。