breaking strength中文,breaking strength的意思,breaking strength翻译及用法

2025-07-18 22:21 浏览次数 4

breaking strength

英[ˈbreikiŋ streŋθ]美[ˈbrekɪŋ strɛŋkθ]

裂断强度,[力] 抗断强度

breaking strength 英语释义

英语释义

    1. the greatest stress especially in tension that a material is capable of withstanding without rupture

breaking strength 片语

片语

breaking factor strength裂断强度

Measurement of breaking strength抗断强度的测量

rope breaking-strength test钢丝绳抗断强度试验

breaking up strength我不知道

breaking resistance抗断强度;抗裂强度

breaking tensile strength断裂拉伸强度

breaking g strength抗断强度

netting breaking strength网片断裂强度

rope breaking strength tester钢丝绳断裂强度试验计

loop breaking strength勾接断裂强力

breaking strength 例句

英汉例句

  • there are changes in mechanical properties of the fabric such as weight, thickness, stiffness, permeability, or breaking strength and elongation.

    有织物机械性能的改变,诸如重量,厚度,硬度,透气,断裂强力和伸长度等性能的改变。

  • change relation of breaking strength and work of break of soybean protein fiber polyester fiber blended yarn and soybean protein fiber cotton fiber blended yarn is consistent.

    大豆蛋白纤维涤纶纤维混纺纱、大豆蛋白纤维棉纤维混纺纱的断裂强度和断裂功随混纺比的变化关系基本一致。

  • the breaking strength and initial modulus of the ptt/poy were increased with the take-up velocity while the elongation at break and the specific work to rapture were decreased.

    随卷绕速度的提高,ptt/poy的断裂强度和初始模量增加,而断裂伸长率和断裂比功降低。

  • the results showed that the breaking strength of uhmwpe fiber was improved after dipping treatment, which was decreased with the increase of twist.

    结果表明,uhmwpe纤维的断裂强力随着纤维捻度的增加而减小,纤维浸胶处理后的断裂强力增大;

  • the intensity curve of cable is divided into four typical phases. the yield strength, breaking strength and elastic modulus can be calculated and the elastic modulus is basically a constant.

    通过系缆强度性能实验分析了系缆强度曲线四个阶段,得到了系缆屈服强度、破断强度、弹性模量等性能指标。

  • effect of adding dietary fiber on the breaking strength and breaking strain of fresh water fish surimi gel was investigated .

    研究了添加膳食纤维对白鲢鱼糜凝胶破断强度和凹陷度的影响。

  • the static triaxial test of two engineerings shows that the breaking strength of asphalt concrete declines significantly as the temperature rises and the strain increases noticeably when breaking.

    两个实际工程的静三轴变形与强度试验表明,随着温度升高沥青混凝土破坏强度明显降低,破坏时应变明显加大;

  • cross breaking strength of spunlaced nonwovens is an important machinery property index of spunlaced product.

    水刺非织造布的横向断裂强力是水刺产品的一项重要的机械性能指标。

  • tibia breaking strength in no inorganic p group was lower than the other groups, and it was significantly lower than the other groups at 28d of the age (p 0.05).

    肉鸡胫骨折断强度无磷酸氢钙组低于其他各组,其中28日龄该组肉鸡胫骨折断强度显着低于其他组(p0.05);

  • the paper mainly studied the air - jet textured processing for twisted glass fiber yarn, and analysed the effects of the chief parameters on the texturing and breaking strength of the textured yarn.

    主要研究玻璃纤维有捻长丝纱的变形制造工艺及工艺参数对变形纱变形效果和断裂强度影响。

  • used to measure breaking strength of bundle fiber of cotton, wool and.

    用于测定棉、化纤、毛等束纤维的断裂强力。

  • the breaking strength of extrudates was inversely related to the radial expansion.

    挤出物的破裂强度与径向膨胀呈反比关系。

  • heat shrink temperature and breaking strength tests were carried out.

    分组测定热皱缩温度及断裂强度。

  • the breaking strength of grafted membrane increases with the increasing of grafting degree, but it does not change obviously by self-cross-linking.

    接枝膜的拉伸断裂强度随接枝率的增加而提高,但是辐射自交联无法显着提高膜的力学性能。

  • results show that, crystalline, crystallite size, breaking strength and initial modulus of the fiber are all decreased after graft copolymerizations of ma.

    分析讨论了纤维接枝后结晶度的变化情况,及结晶度与力学性能的关系,结果表明接枝ma后纤维的结晶度、晶粒度、断裂强度和初始模量均有下降。

  • in this paper, the problem of consistency is investigated for the specific breaking strength of cotton measured on different tensile testers.

    本文就各种强力仪测定棉纤维断裂比强度指标具有一致性的问题进行研究。

  • experiments reveal that the apparent viscosity of the melt flameretardant pp decreases with increasing additive. the breaking strength of flameretardant pp fiber decreases with increasing additive.

    结果表明,随阻燃剂的增加熔体的表观粘度下降,并且阻燃纤维的断裂强度也下降。

  • results showed that after ionization breaking strength of tipn increased obviously and kept maximum when the degree of ionization of p(st-mma)was about 25% in tipn.

    离子化后tipn的拉伸强度明显增加,在离子化程度为25%时达到最大,断裂伸长率明显下降。

相关热词