英语释义

• a gaseous hydrocarbon C4H6; used in making synthetic rubbers

片语

butadiene latex丁二烯胶乳

butadiene dispersions苯乙烯丁二烯分散剂

styrene butadiene rubber[橡胶] 丁苯橡胶；充油丁苯橡胶

butadiene dimer[高分子]

butadiene polymer二烯聚合物

acrylonitrile butadiene rubber丁腈橡胶

butadiene peroxide丁二烯过氧化物

butadiene hydrocarbon二烯烃

butadiene styrene rubber丁二烯苯乙烯橡胶

butadiene catalyst丁二烯

butadiene device丁二烯装置

butadiene rubber[橡胶] 丁二烯橡胶；聚丁橡胶

3 butadiene丁二烯

英汉例句

• the oxidative dehydrogenation of butane to butene and butadiene was studied by using conventional fixed bed reactor (fbr), inert membrane reactor (imr) and mixed inert membrane reactor (mimr).

  比较了固定床反应器（fbr）、惰性膜反应器（imr）与混合式惰性膜反应器（mimr）用于丁烷氧化脱氢制丁烯和丁二烯反应的性能。

• in the process, oil is top gas (often reduced pressure), chemical is butadiene unit, the torch gas recovery system, oil and chemical are used.

  工艺上用的，石油是塔顶气（常减压），化工是丁二烯装置，火炬气回收系统，石油和化工均采用过。

• synthetic rubber is a copolymer of butadiene and styrene.

  合成橡胶是丁二烯和苯乙烯的共聚物。

• the versatility of abs is derived from its monomer building blocks acrylonitrile, butadiene and styrene.

  abs的多功能性来源于其三种组成单体丙烯睛，丁二烯和苯乙烯。

• based on the practical data and operation program , both kinetic and engineering analyses of nickel catalyzed butadiene rubber production by tank reactor in china were reviewed .

  根据我国镍系顺丁橡胶的生产数据和工艺方案，对釜式丁二烯聚合工艺进行了动力学分析和工程分析。

• under these conditions, an excellent yield of butadiene approximately 80% and selectivity about 90% can be obtained.

  在上述条件下取得了优异结果，丁二烯收率约为80%，选择性90%左右。

• the oxidation further enhances the physical properties of carbon black filled nitrile butadiene rubber (nbr).

  氧化后的碳黑进一步加强了硝基丁二烯橡胶的物理性能。

• possibility reaction mechanism was proposed, which could be used to explain the spontaneous termination reaction in anionic polymerization of butadiene in the presence of polar additives.

  对这些破坏活性中心的反应所提出来的反应机理，可以用于解释丁二烯阴离子聚合中的自发终止现象。

• synthetic rubber is a copolymer of butadiene (75%) and styrene (25%).

  合成橡胶是丁二烯（75％）和苯乙烯（25％）的共聚物。

• the extractive rectification of butadiene has been investigated by pattern recognition. the condition of optimization for two response variables has been found, and confirmed in production practice.

  试用模式识别方法分析丁二烯萃取精馏过程，获得了两个控制目标的公共优化条件，并在生产过程的数据中得到证实。

• it is through full or partial hydrogenation of the double bond of butadiene nbr while to get.

  它是通过全部或部分氢化nbr的丁二烯中的双键而得到的。

• the existing problems in bottom tower control of butadiene rectifying tower in certain plant are investigated. the inference control strategy based on soft measurement is stated.

  研究了某厂丁二烯精馏塔塔底控制回路目前存在的问题，提出了基于软测量的推断控制方案。

• the light constituents flow upward to the catalyst zone, where the selective hydrogenation of butadiene is carried out together with desulfurization and some olefin saturation.

  轻组分向上流至催化剂段，在那里丁二烯选择性加氢、脱硫和一些烯烃的饱和同时进行。

• the process of oxidative dehydrogenation of butene to butadiene catalyzed by b - 02 is studied in a gas - solid - solid circulating fluidization reactor (gsscfr) .

  研究了用b-02催化剂在气固固循环流化反应器内进行丁烯氧化脱氢制丁二烯的过程。

• in order to verify the modeling effect of the system, soft-measurement models of key components of butadiene distillation column in a factory are studied by using the system.

  为了在实际应用中验证本系统的开发效果，本文以某厂丁二烯精馏塔为研究对象，借助本系统对其关键组分作了建模研究。

• furthermore, the effects of gabe on polymerization kinetics, microstructures of polymer and coupling reaction in the copolymerization of butadiene and styrene are investigated thoroughly.

  进而全面考察了gabe对丁二烯、苯乙烯阴离子共聚合的聚合动力学、聚合物微观结构及偶联反应的影响规律。

• lego bricks start out as granulated acrylonitrile butadiene styrene (abs), a type of shiny plastic used to make everything from hard hats to toys to pipes.

  乐高积木始于小颗粒状的丙烯腈丁二烯苯乙烯（abs），一种闪亮的可以被用于制造从硬帽子到水管的塑料。

• the authors make an introduction to the plan of improving the safety of the butadiene spherical tank group and its engineering practice.

  本文介绍了丁二烯球罐群安全隐患的清除方案及工程实施。

• through side-stream test, the result of butadiene removal by dd-1, service life, butene loss, and the influences of reaction velocity and reaction temperature on the catalyst are analyzed.

  通过侧流试验分析了dd-1脱除丁二烯的效果、使用寿命和丁烯损耗情况、反应空速和反应温度对催化剂的影响。