片语

stiffness s coefficient刚度系数

stiffness reducing coefficient刚度折减系数

stiffness decrease coefficient刚度降低系数

stiffness correction coefficient刚度修正系数

stiffness influence coefficient刚度影响系数

stiffness rebate coefficient刚度折减系数

stiffness reduction coefficient刚度减小系数

stiffness influience coefficient劲性影响系数

stiffness reduced coefficient刚度折减系数

英汉例句

• by the test of anchor cable pull-out intensity, research is carried on anchor capability, stiffness coefficient and prestress losses of anchor cable in reinforcing similar soil slopes.

  通过锚索抗拔试验研究了类土质边坡的锚固力大小、锚索刚度系数和锚索预应力损失情况；

• meanwhile, by some examples studied, the reasonable range of stiffness coefficient has been obtained during the discrete element calculating.

  同时，本文还通过算例分析，得到离散单元的计算中块体的刚度系数选取的合理范围。

• for partial prestressed concrete high-rise tower structure, stiffness coefficient is independent of prestress level, ratio of reinforcement and external load effect, etc.

  对于部分预应力混凝土高耸结构，截面刚度系数与预应力水平、外荷载及截面配筋率等很多因素有关。

• the relation between the internal force coefficient and connective stiffness coefficient of beam is studied and also the factors that affect the relation.

  分析框架的内力系数和梁的连接刚度系数之间的关系，和影响它们关系的因素。

• the formulas of moment coefficient and connective stiffness coefficient single with the single span–layer frame under vertical loads are presented.

  计算了单层单跨框架在竖向荷载下弯矩系数和连接刚度系数的函数公式。

• the equivalent damping ratio and stiffness coefficient of the led device are studied, and the general equivalent formula of energy dissipation devices is established.

  研究了将铅挤压阻尼装置等效成阻尼比和刚度系数的方法，建立了消能装置的通用等效计算公式；

• selection methods on damping coefficient, stiffness coefficient and time step in granular distinct element method;

  用一种新的方法—等效动刚度系数法对转子的动平衡进行了研究。

• stiffness coefficient of rolling mill was calculated and indentified surveying rolling pressure by installing the resistance strain sensor on four-high reversing mill.

  文章通过在四辊可逆式轧机上安装电阻应变式传感器实测轧制压力，计算轧机的刚度系数，并对刚度系数进行验证。

• finally the expression of system stiffness coefficient and system damping coefficient in arbitrary docking mode are reached.

  最后给出了差动式机电缓沖阻尼系统在一般工况下工程实用的刚度和阻尼系数简化模型。

• the values of static average resistant force and impact stiffness coefficient used for the solution are determined based onthe results obtained from the experiments.

  提出了核电站在强地震作用下安全停堆时间的计算方法，并根据实验结果确定了计算中所需的静态平均阻力及碰撞刚度系数。

• by which linear and nonlinear frequency response function was estimated, and nonlinear stiffness coefficient and damping coefficient of the model were optimized by least square method in this paper.

  利用该方法对非线性频响函数进行估计，并利用了最小二乘法对模型的非线性刚度系数和非线性阻尼系数进行了优化。

• the horizontal stiffness coefficient values of rock anchor under different conditions are obtained through using numerical method to simulate the pullout test of the fully-grouted rock anchor.

  采用数值方法，模拟全粘结巖石锚桿的拉拔试验，求得不同条件下的巖石锚桿水平刚度系数，最后经曲线拟合和参数分析，推导出巖石锚桿水平刚度系数的计算公式。

• ansys software is used in calculation. the calculation modeling considers stiffness coefficient and damping coefficient of the journal bearings, and gears engagement.

  在计算中使用了有限元软件ansys ，其中所用的模型可以计入滑动轴承的刚度系数和阻尼系数以及齿轮的啮合。

• the time which the valve core takes by reaching the balance position and the maximum position will reduce linearly when the spring stiffness coefficient increase;

  弹簧劲度系数与阀芯达到的最大位移、平衡位置位移呈线性递减关系；

• the mechanical analytic model was developed, and the analytic expressions of the displacement, the stiffness coefficient and the resonance frequency were stated as well.

  建立该驱动器的力学分析模型，给出位移、弹性系数和谐振频率的解析公式。

• at the same time, stiffness coefficient k to control addition of stiffness of cement-emulsified asphalt mixture was put forward.

  同时提出用刚化系数k来控制水泥-乳化沥青刚度的增加。

• by extending stiffness coefficient into stiffness matrix, the deformation and elastic force of tensile-spring coincides with lorentz transformation.

  通过把劲度系数扩展为矩阵形式，拉伸弹簧的形变与弹力在罗伦兹变换中得到了统一。