英汉例句

• the calculation of critical buckling load of struts is according to the condition of the end restraint.

  工程结构中受压构件的临界屈曲载荷的计算，是按理想端部约束条件求得的。

• at one time, the buckling analysis of structures with different rise-to-span were made, and discovered that buckling load and stability can be improved with high rise-to-span.

  同时文中还对不同矢跨比下的该结构作了屈曲分析，发现增加矢高可显着提高结构的极限屈曲荷载，改善结构的几何非线性稳定性能。

• by solving the disturbed equations, the bifurcation condition of the dynamic buckling, critical buckling load and buckling mode are obtained.

  通过求解扰动方程得到了动态屈曲的分叉条件、临界载荷和屈曲模态。

• under axisymmetrical compressive conditions, the critical buckling load of sea ice plate is given.

  在轴对称条件下，给出海冰板的环向屈曲临界载荷。

• the relationship between the buckling load of the longitudinal frame and the stiffness of bracings and the formula for the critical stiffness requirement were put forward using the analytical method.

  进一步利用解析法确定了支撑刚度同为有限时，屈曲荷载与支撑刚度的关系以及柱列无侧移失稳的门槛刚度要求表达式。

• the results showed that the buckling load of shell decreased when the delamination length increased and the delamination position was nearer to the surface and the axial center of the shell.

  结果表明：脱层长度越大、越靠近壳的外表和壳的轴向中心，结构的屈曲载荷越低；

• the relationship of critical buckling load and fiber bridge stiffness are approximately linear. the greater the fiber bridge stiffness, the smaller the buckling region.

  屈曲临界载荷随着纤维刚度系数的增大而增大，脱层屈曲的临界载荷与纤维刚度系数近似成线性关系。

• the critical buckling load is influenced by the pattern of bottom-hole assembly directly.

  下部鉆具组合的具体方式将直接影响其所能承受临界失稳载荷的大小。

• the research of local buckling occurred in coped beam is still rare. besides the coped size and other relative parameters have a large influence on buckling load of steel beam.

  关于切口钢梁的局部屈曲研究目前还相对较少，切口尺寸以及其他相关参数在很大程度影响钢梁的屈曲荷载。

• thus, for the slender struts supported on the elastically system, the influence of the bearing deflection on the critical buckling load must be considered.

  因而对支承于弹性系统上的细长压桿，需考虑支坐变位对临界屈曲载荷的影响。

• the results show that when the thickness is not very small, non axisymmetric critical buckling load is higher than axisymmetric one;

  数值结果表明：当壳壁厚不很薄时，轴对称屈曲临界载荷比非轴对称临界载荷高；

• this paper presents a method for calculating the buckling load and mode shape of aring-stiffened circular cylindrical shell subject to hydrostatic pressure.

  本文给出了以环肋加强的圆柱壳在液压作用下屈曲形态和临界载荷的计算方法。

• the results show that the crippling strength and local buckling load of shot peened specimens are reduced.

  试验结果表明：喷丸后壁板的压损强度和局部屈曲载荷均有所降低。

• the effect of initial imperfection and elastic-plastic behavior on the buckling load is considered in the fem analysis, and the curve of load-deflection in the post buckling stage is obtained.

  分析中考虑了初挠度和弹塑性对耐压壳体失稳压力的影响，得到了后屈曲阶段的载荷─挠度曲线。

• the effects of the connectors on the critical buckling load and the bending stress of pipes in horizontal section are analyzed.

  分析了鉆桿接头对水平井段鉆柱屈曲临界力和弯曲应力的影响，提出了计算鉆柱正弦屈曲临界力的新方法。

• critical buckling load of all plate specimens was derived based on elastoplastic theory.

  利用弹塑性理论推导了各组板试件的屈曲临界载荷。

• in this paper, a dynamic evaluative method is provided to define the buckling load of oilfield derrick.

  提出一种确定石油鉆井井架结构屈曲荷载的动态评估方法 。

• three difference buckling modes of delaminated shell were considered. the influence of boundary condition, length and depth of delamination on buckling load was analyzed.

  考虑脱层壳的三种不同屈曲模态，分析了边界条件、脱层长度、深度对脱层壳屈曲载荷的影响；

• present paper takes a tubular boom as an example to prove that it is precise enough to use energy method to find buckling load of a boom.

  本文以管形变截面臂架为例，证明用能量法求臂架的屈曲载荷相当準确。

• based on the relationship between the buckling load of a rigid column and the bracing stiffness, the critical stiffness requirement of the bracing for a single column was obtained.

  本文首先利用刚性单柱屈曲荷载增量与支撑刚度的关系，得到了单柱横系桿支撑、斜拉桿支撑的门槛刚度要求。

• finally, buckling load and mode can be calculated from the characteristic equation.

  最后由屈曲方程计算含内埋矩形脱层壳的屈曲载荷和屈曲模态。