片语

determination of bath temperature定温

Oil-bath furnace temperature control油浴炉控温方式

salt bath temperature盐温

melting bath temperature熔池温度

oil bath temperature油浴温度

water-bath temperature水浴温度

gel-bath temperature凝胶浴温度

cooling bath temperature冷浴温度

英汉例句

• the ultrafiltration rate of pure water with the coagulation bath temperature increased.

  随着凝固浴温度的升高，所成的膜的透水速率上升。

• in order to make full use of the bof online offgas analysis system at bensteel, dynamic models were developed based on mass balance and the bath temperature calculated from the reaction equilibrium.

  结合本钢炉气分析在线系统，建立了应用物料平衡原理预测碳含量及根据反应平衡原理预测温度变化的转炉动态模型。

• besides the cell voltage, bath temperature and bath ratio, the inputs of the system also include the liquidus temperature, superheat extent and cathode voltage.

  系统的输入参数除传统的电压、温度和分子比外，还采用初晶温度、过热度和阴极压降等作为系统的输入参数。

• the effects of spinning dope concentration, coagulation bath temperature and addition of persimmon leaves on the mechanical properties of blend fiber were studied.

  研究了纺丝原液浓度、凝固浴温度、柿叶添加量对共混纤维的力学性能的影响。

• try to put vanities, bath temperature water, such as water turbidity found to water until the clear-up .

  要试放面盆、浴缸的冷热水，如发现水质混浊，须放水，直到水清为止。

• the results showed that decreasing in current density and bath temperature could promote the structural transformation of cr coating from crystalline to non-crystalline state.

  降低电流密度和溶液温度，均可促进铬镀层由晶态向非晶态转变，该转变是由氢引起的。

• to comprehend the change law of bath temperature in blowing of large converter the sublance is used for measuring the temperature and sampling analysis.

  为了了解大型转炉吹炼过程中熔池温度的变化规律，利用副枪在转炉吹炼过程中进行了测温和取样分析。

• special procedures are used to ensure that these crosslinkers will not react at bath temperature to cause instability.

  通过采用一些特殊的处理工艺，确保这些交联剂不会在槽液温度起反应而引起槽液的不稳定性。

• the studies on stability of pu-sio2, pes-sio2 suspensions and influence coagulant bath temperature on flat membrane were carried out.

  研究了无机粒子填充聚合物悬浮铸膜液的稳定性及凝固浴温度对平板膜成形的影响。

• the effects of precursor concentration, peg2000 content and water bath temperature on the characteristics of films were studied.

  研究了前驱体浓度、peg2000加入量及不同水浴温度对薄膜结构和性能的影响。

• coagulant bath temperature had a strong influence on pu, pes composite flat membrane.

  凝固浴温度对填充聚合物平板膜有很大影响。

• the retention rates of albumin bovine decreases when coagulation bath temperature increases, and first decreases, then increases when pre-evaporation time prolongs.

  对牛血清白蛋白的截留率随着凝固浴温度的上升而下降，随着预蒸发时间的延长先略有下降然后上升。

• the accuracy of the prediction is determined by the reliability of initial carbon content. the bath temperature is a function of the carbon content and the co, co2 partial pressure.

  熔池温度是碳含量及炉气中co和co2分压的函数，其中吹炼过程的平稳性是模型最终预测结果準确获得的保证。

• the influence of ammonium molybdate, cobalt sulphate, ammonium bifluoride, acidity of blackening bath, blackening bath temperature and time on film quality were studied.

  研究了钼酸铵、硫酸钴、氟化氢铵、黑化液酸度、黑化液温度及时间对膜质量的影响。

• these crosslinkers are stable in water at normal bath temperature but become reactive at curing temperatures.

  这些交联剂于正常槽液温度下在水中很稳定，但在固化温度下就变得活泼起来。

• based on this platform, a fuzzy expert system of aluminium fluoride「s feeding is developed. it is applied to controlling of the aluminum electrolysis」s bath temperature and ratio.

  以此专家系统为平台，开发了电解铝过程中氟化铝添加的模糊专家系统，控制电解质温度和分子比。

• the effects of current density, bath temperature and coating thickness on the solderability and wetting balance of pd coating electroplated on phosphor-bronze were studied.

  研究了电流密度、镀液温度及镀层厚度对磷青铜上钯镀层的焊锡性与润湿平衡的影响。

• thermal equilibrium can be used for predicting bath temperature at endpoint only with stable raw materials supply and operation.

  只有减小原料条件的波动和稳定操作，才可用热平衡方法预测吹炼终点熔池温度。

• the results showed that the properties of the regenerated bamboo fiber prepared with lower coagulation bath temperature were improved.

  实验结果表明：在较低的凝固浴温度下纺制得到的再生竹纤维素纤维的性能较好。

• it was noted that when coagulation bath temperature was increased, crystallization could be suppressed, and more porous structure was obtained on the surface of the membrane.

  另外，凝胶浴温度升高可以抑制结晶现象，并使膜表面孔径和孔密度增加。